Daytime BC16 Kullanım Kılavuzu - Sayfa 7

Kontrolör Daytime BC16 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Daytime BC16 12 sayfaları. Single-channel for matrix

3. Setting the clock:

The time can be set at any time using the buttons. The hour can be adjusted hour-by-hour and the

minutes can be adjusted in 5-minute increments.

The time is set as follows:

1. Press the S1 button and hold down for max. 5 second

a. Press the S2 (HOUR) button so that the current hour is set.

Then adjust the minutes by pressing the

b. S3 button (in 5-minute increments)

2. Release the buttons. The status LED lights green after a short time, signalling automatic

mode.

The status LED will illuminate red each time the S2 or S3 button is pressed.

For example: the current time is 13:10

Press S1 and hold. Then, within no more than 4 seconds, press the S2 button 13 times. Then

press the S3 button twice (two 5-minute increments). Release the buttons. The status LED lights

green after a short time, signalling automatic mode.

During a power outage or after the power supply is disconnected, the internal clock runs for an

additional 15 minutes (the power reserve). In such a case, the Status LED will flash regularly to

signal that the clock is still running. The first 10 minutes are signalled with green flashes. After 10

minutes, the LED will flash red unit the power reserve is empty. The device will switch immediately

back to normal mode if the operating voltage is reapplied/reconnected during this power reserve

phase. The status LED will stop flashing once the power reserve is empty. The time on the clock

must be set again once this time has expired. All other saved values are retained. The status LED

will flash red once the operating voltage is applied. After the time is set, the status LED will

illuminate green again.

4. Setting the start of sunrise and sunset:

Press and hold S1 for about 8 seconds until the status LED illuminates red. Then release S1.

Repeatedly press the corresponding button (e.g. S2 for start of sunrise; S3 for start of sunset) the

proper number of times according to the desired time

(for example Sunrise start should be 06:00 -> then press S2 6 times / Sunset start should be 18.00

-> then press S3 18 times ). Press the S1 button to save and start normal operations.

Note: You should always specify both of these time points. However, if only one time point is

changed, the other time point will automatic be set to 0:00!