Hibiscus Citizen CLP 8301 Kullanıcı Bilgilendirme Kılavuzu

Yazıcı Hibiscus Citizen CLP 8301 için çevrimiçi göz atın veya pdf Kullanıcı Bilgilendirme Kılavuzu indirin. Hibiscus Citizen CLP 8301 2 sayfaları. Replacing print head

Sayfayı Yazdır

Switch OFF the printer.

Open the Printer Cover - release and raise the print head assembly - remove the ribbon.

Remove the ribbon guide bar:

a) With finger or thumbnail, lift the catch on the upper black plastic retainer and slide away from the head assembly.

b) Lift the ribbon guide out of the lower retainer, leaving that retainer in place.

See Diagram 1.

Using both hands, press the printhead back against the spring mechanism maintaining an even pressure on both ends,

and sliding away from you to disengage the locking spurs and release the head from the carriage assembly.

See Diagram 2.

Diagram 2

Carefully remove the head and disconnect from the carriage assembly by unplugging the wire harness.

Gently lift the edge of the plastic strip on the underside of the new print head to reveal and note down the head

resistance value.

See Diagram 3.

Plug the new head into the wire harness.

Slot the new head into the carriage assembly and press in against the spring mechanism, sliding towards you to engage

the locking spurs.

Re-seat the ribbon guide bar in the lower retainer clip and slide the upper retainer back onto the carriage assembly

until it locks in place.

PTO

For technical support on printer issues call 0113 2424272 and ask for IT Support

Hibiscus PLC, Hudswell Road, Leeds LS10 1AG

Citizen CLP 8301 – Replacing Print Head

Diagram 1

Diagram 3

HIBSOFT INFORMATION GUIDES

Page: 1