Automatic SA200-A Kullanım Kılavuzu - Sayfa 9

Sander Automatic SA200-A için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Automatic SA200-A 11 sayfaları. 200w 1/3 sheet sander

Sayfayı Yazdır

• Never force the tool. Excessive pressure may decrease

the sanding efficiency, damage the abrasive paper or

shorten tool life. Hold the tool firmly. Turn the tool on and

wait until it attains full speed. Then gently place the tool

on the workpiece surface. Keep the pad flush with the

workpiece and apply slight pressure on the tool.

Using the sander

1. The sander is designed for sanding wood, plastic and

similar materials. It can be used for sanding back and

finishing the surface.

2. This sander is a handy size for medium jobs.

3. Wear safety goggles, a dust mask and ear defenders.

4. The whole sanding pad must rest on the workpiece.

5. Switch the sander on while it is off the workpiece and

move it over the surface to be smoothed in a circular

motion.

6. Grip the rear of the handle in one hand and push down

on the front of the handle with the other hand. Take

care to hold the sander parallel to the work.

7. Use moderate pressure only, enough to control the

machine without labouring the motor.

TIP: When sanding a rough or painted surface, start

off with a course grit and work your way through to a

finer one until the desired finish is achieved.

8. If there are still marks on your work after sanding,

try either going back to a coarser grade and sanding

the marks out before recommencing with the original

choice of grit, or try using a new piece of sandpaper to

eliminate the unwanted marks before going on to a finer

grit and finishing the job.

WARNING: Do not use the sander in wet or damp

conditions.

To maximise the life of the motor do not use the sander

continuously for more than 10-15 min at a time. Allow 5-10

min rest period between usage.

Using the hole punch

If the sandpaper installed does not have holes it will be

necessary to punch holes into the sandpaper using the

hole punch provided to ensure dust collection during use.

Place the hole punch on a level surface. After fitting the

sandpaper to the sander align the base of the sander with

the hole punch and push down on the sander until the hole

punch pierces the sandpaper. Remove the sander from the

hole punch.

TIP: Depending on the paper used, you may need to use a

pointed screwdriver to open and clear the holes to increase

the efficiency of dust extraction.

Selecting the right grade of sandpaper

WARNING: Always ensure that the tool is switched

off and the plug is removed from the power point before

making any adjustments or maintenance procedures.

• Different grades of sanding paper can be purchased from

your local hardware store. Available grades are: Coarse,

Medium and Fine.

• Use a coarse grit to sand down rough finishes, medium

grit to smooth the work and fine grit to finish off.

• It is best to make a trial run on a scrap piece of material

to determine the optimum grades of sandpaper for

a particular job. If there are still marks on your work

after sanding, try either going back to a coarser grade

and sanding the marks out before recommencing with

the original choice of grit, or try using a new piece of