HIBLOW hp-150 Kullanım Kılavuzu - Sayfa 3

Hava Kompresörü HIBLOW hp-150 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. HIBLOW hp-150 13 sayfaları. Air pumps
Ayrıca HIBLOW hp-150 için: Manuel (8 sayfalar), Kullanım Kılavuzu (17 sayfalar)

Sayfayı Yazdır

GROUNDING INSTRUCTIONS

FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the

risk of electric shock by providing an escape wire for the electric current. This is equipped with a

cord having a grounding wire with an appropriate grounding plug.

The plug must be plugged into an outlet that is properly installed and grounded in accordance with

all local codes and ordinances.

Improper installation of the grounding plug can result in a risk of electric shock.

DANGER:

If repair or replacement of the cord or plug is necessary, do not connect the

grounding wire to either flat blade terminal. The wire with insulation having an

outer surface that is green, with or without yellow stripes, is the grounding wire.

Check with a qualified electrician or serviceman if the grounding instructions are not completely

understood, or if in doubt as to whether the product is properly grounded. Do not modify the plug

provided; if it will not fit the outlet, have the proper outlet installed by a qualified electrician.

For a grounded, cord-connected product rated less than 15

amperes and intended for use on a nominal 120 volt supply circuit.

This product is for use on a nominal 120 volt circuit, and has grounding plug. Make sure that the

product is connected to an outlet having the same configuration as the plug. No adapter should be

used with the product.

FOR PERMANENTLY CONNECTED PRODUCT

This product should be connected to a grounded, metallic, permanent wiring system, or an

equipment-grounding terminal or lead on the product(refer to wiring diagram).

WIRING

120V AC Wiring Diagram

Grounded

Outlet

Grounding

Black lead options for Shaded Pole Motors

Outlet Box

Black

Green = Ground Screw

White/Red (+)

Grounded

Cover

Line

Voltage