Emergi-Lite Prestige Series Manuel
Aydınlatma Ekipmanları Emergi-Lite Prestige Series için çevrimiçi göz atın veya pdf Manuel indirin. Emergi-Lite Prestige Series 2 sayfaları. Edge-lit led exit series
Sayfayı YazdırPrestige Series - Edge-Lit LED Exit Series
Flat trim AC, AC/DC and Self-Powered models
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
6. Do not use this equipment for other than intended use.
7. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
Turn off AC power.
Installation
(Figure 1)
1. Remove the proper knockout in the back box for the entry of the AC
wires.
2. Assemble the recessed mount brackets to the back box (see figure
2). Install the bar hangers in the adjustment brackets . Mount the
back box so that it is flush with the ceiling surface.
3. Route AC unswitched circuit of rated voltage into the back box and
leave 6" of wire length.
4. Connect the incoming ground to the short ground wire provided in the
back box.
5. Electrical connection (Figures 3,4)
a. Connect the long ground lead with eyelet from the back box to the
trim plate assembly with the hardware provided.
b. Make the proper connections. Our system can accept input volt-
ages of 120 VAC to 347 VAC. For regular models connect the
purple (hot) and white (common) leads to the building utility (Fig-
ure 3). For models with diagnostic feature connect the white
(common), black (120 VAC) or orange (277 VAC) leads to the
building utility (Figure 4).
c.
AC/DC Models only:
For DC portion: wire the Red lead (+) to the positive DC input voltage
and the Blue lead (-) to the negative DC input voltage. Note: DC input
voltage range is 6 volts to 24 volts.
6. Compress the retention springs (Figures 5) and insert the trim plate
assembly in the back box. Align to be flush with the back box or with
the ceiling.
Emergi-Lite
Tel: (888) 552-6467
Figure 1
Part List
1. Back box
2. Adjusment brackets (2)
3. Bar hangers (2)
Figure 2
Fax: (800) 316-4515
www.emergi-lite.com
Prestige Series - Edge-Lit LED Exit Series
4. Trim plate assembly
5. Clips (2)
6. Exit panel
07/09 750.1436 Rev. A
1/2