Automatic WTLD018 Kullanım Kılavuzu - Sayfa 11

Matkap Automatic WTLD018 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Automatic WTLD018 16 sayfaları. 20v drill/driver

Sayfayı Yazdır

Battery charging

IMPORTANT. Before attempting to charge the battery,

check the charger and the battery to ensure the charging

equipment matches the battery supplied. The components

are all labelled with component numbers.

IMPORTANT. The battery will be fully charged after 3-5

hours, remove it from the charger after this time. Do not

leave a battery charging for longer than 24 hours.

Note: It is suggested to remove the battery from the drill for

the charging process. Do not attempt to use the drill while

the charger is connected to the battery.

1. To commence charging, plug

in the adaptor from the plug

pack charger (10) into the

back of the battery and insert

firmly into place.

2. Plug in the plug pack charger

and switch on at the power

supply. The green LED

indicator located on the

back of the battery will indicate that the battery is being

charged. The red light on the back of the battery indicates

the battery is connected to the turned on charger.

During the charging process the Red and the Green

lights are on. When the battery is fully charged the red

light remains on while the green light turns off.

3. The battery charging time is approximately 3-5 hours.

4. When the battery is fully charged turn off the plug pack

charger power supply from the mains and remove the

charger plug from the battery.

Both the battery pack and the charger may become warm

to touch. This is also normal and not an issue of concern.

Both the battery pack and plug pack charger are fitted

with thermal safety devices and they will shut down if the

temperatures become too high.

To obtain the best life for the battery

Never allow the drill to come to a complete stand still

before recharging. The battery should be placed on charge

whenever the battery is noticeably running down or the drill

no longer performs a task it previously performed.

Avoid allowing lose items like screws or nails etc. to be

stored with battery packs as these or similar items can short

battery packs and cause a fire or explosion.

Always unplug the plug pack charger when not in use and

store in a dry secure place.

Avoid charging or storing your battery in temperatures

below 0ºC and above 40ºC.

Battery indicator

Press the trigger switch fully so the motor is running at

no load full speed, press the indicator button and refer to

the LED lights. The LED lights indicate the level of charge

remaining in the battery.

The table overleaf explains the levels of charge

(low, medium and high).