HiBoost Commercial 30K Pro Kullanıcı Kılavuzu - Sayfa 9
Genişletici HiBoost Commercial 30K Pro için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HiBoost Commercial 30K Pro 20 sayfaları. Mobile signal booster
Sayfayı Yazdır
1.7 Run coaxial cable
Loosely run the supplied coaxial cable from your outdoor antenna to your
booster connector marked "Outdoor". We recommend applying waterproof
tape to fully waterproof the connection.
Connect the indoor antenna cables from your indoor antenna to the booster
connector marked "Indoor". Tighten the connection by hand.
(After you have tested the system you can permanently secure the coaxial
cable).
As you route and pull cabling, follow these general guidelines:
- Bend cables and route them smoothly, and protect the outer skin against any
damage.
- Keep horizontal cables straight and fasten them with a tie every three to five
feet.
. Bind and fasten vertical cables every six to eight feet.
. Waterproof all connectors between outdoor antenna and coaxial cables with
waterproof tape to avoid water or other kinds of damage.
. Be careful when plugging the connector in so as not to damage the center pins
on the connectors.
1.8 Power up your signal booster
Once all the following precautions have been taken, power on the signal
booster.
1. Verify that you have left at least 20 feet of vertical separation space between
the indoor and outdoor antennas.
2. Never point the front of outdoor antenna towards the inside of the indoor
antenna.
3. Verify that the supplied coaxial cables from both the outdoor antenna and the
indoor antenna are properly connected to the signal booster before
powering it up.
4. Carefully plug in the supplied power adaptor into the signal booster where it
is marked 'DC 12V' and connect the other end to a power outlet.
The LED indicator marked power should light up green.
SIGNAL BOOSTER STATUS
Overview: The booster has a smart startup system. When you have finished the
booster system installation and power on the booster, it will start its initialization
process to check the received downlink signal from the cell site and the isolation
status. This an automatic process designed to ensure its best performance. This
will take approximately 3-5 seconds.
After the booster starts up, please check if the coverage is good. If it is good, the
booster system installation is complete. If the coverage is not adequate, please
9/19