HiBoost F10G-5S-LCD Kullanıcı Kılavuzu - Sayfa 16

Genişletici HiBoost F10G-5S-LCD için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HiBoost F10G-5S-LCD 18 sayfaları.

them. The signals travel like rays of sunlight, a directional antenna will send the signal

in the direction that it is pointing. An omni directional antenna will send the signal in

every direction around it. So depending on your equipment it's important to be sure

that your Indoor antenna is not sending the signal back into the outdoor antenna.

THINGS TO CHECK WHEN EXPERIENCING WEAK CELLULAR SIGNAL

1. Ensure the outdoor antenna is pointing in the correct direction and is capturing

adequate signal for the booster.

2. Check all connections on the cable, antennas, and booster.

3. Check cable for bends and or cuts.

4. All LED lights on the booster should be green or there are not "ALC" and "ISO"

indication on LCD.

5. Outdoor antenna and the indoor antennas have adequate separation and are

not causing feedback.

7 FREQUENTLY ASKED QUESTIONS

WHY ARE THE LED LIGHTS TURNING FLASHING GREEN, FLASHING

RED OR SHUTTING OFF?

There are certain cases where your system could be experiencing

oscillation. This can be attributed to either the quality of your input signal

or having your outdoor antenna and indoor antenna too close together. Please

review the following guidelines to help resolve this issue:

1. Adjust the direction of the outdoor antenna. If the system is receiving a very high

input signal, you can point your outdoor antenna away from the cellular tower to

reduce the strength of the input signal and therefore, reduce the oscillation.

Alternatively if your system is receiving a very poor quality signal (weak and

unusable signal), you can point your outdoor antenna more directly towards the

cellular tower to increase the strength of the input signal. Sometimes this may

require completely repositioning the antenna to a location where you can

achieve a line of site to the tower.

2. Increase the separation between the outdoor antenna and the indoor antenna.

This can be achieved by increasing the distance between the two antennas or by

placing barriers between them, such as moving the indoor antenna to an

adjacent room where there would be an additional wall separating them from

the outdoor antenna.

3. Manual Gain Control. Adjust the gain with the manual gain control function

using the dip switches on the side of the booster.

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. End users must follow the specific operating instruction

for satisfying RF exposure compliance. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

https://www.signalbooster.com/ | 1-855-846-2654 | [email protected]