Daytona DJS3GRY Kullanım Kılavuzu ve Güvenlik Talimatları - Sayfa 4

Raflar ve Standlar Daytona DJS3GRY için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Güvenlik Talimatları indirin. Daytona DJS3GRY 8 sayfaları.

Sayfayı Yazdır

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

WARNING! TO PREVENT SERIOUS INJURY: Use as matched pair to support one end of a vehicle only.

Supporting a Vehicle

1. Make sure the vehicle does not exceed the capacity

of the Jack Stands. Note: Check that the weight

is evenly distributed between the Jack Stands.

You must evenly distribute the weight or the

Jack Stands may fail, causing severe injury

or death. Only apply the load vertically.

WARNING! TO PREVENT SERIOUS INJURY: If a

vehicle drops on the Jack Stands (even if it is under

the weight capacity limit), the principle of "dynamic

loading" takes affect. The force of the weight

falling may cause the Jack Stands to fail. A vehicle

weighing much less than the Jack capacity may

cause the Jack Stands to fail if dropped on them.

Note: Do not move the Handle when the Jack

Stands are supporting a vehicle. The shear pin is

designed to shear in the event the user attempts to

move the Handle while supporting weight. If the pin

shears, do not use the Jack Stands again until the

shear pin is replaced by a qualified technician.

2. Examine Jack Stands for cracks or damage before

each use. Do not use if even a minor crack,

bend, or other damage/deformation appears.

Discard Jack Stand if damaged or deformed.

3. Raise the Handle on each Jack Stand

to completely lower the Post.

4. If your are raising only one end of the vehicle,

block the tires that remain on the ground.

5. Following the instructions in your floor jack

manual, raise your vehicle to just above the

minimum height of your Jack Stands.

Removing the Jack Stands

1. Raise the vehicle with a floor jack to take

the load off of the Jack Stands.

2. Remove Safety Pin from the Locking Pin.

Remove the Locking Pin from the Base.

3. Raise the Handle on the Jack

Stands and lower the Posts.

Page 4

For technical questions, please call 1-888-866-5797.

6. Slide your Jack Stands to the proper position points

referred to in the vehicle owner's manual. Make

sure the Jack Stands are on the same point on

each side of the vehicle. Move the Handle up,

and raise the Jack Stands until they are just below

the jack contact point on the vehicle. Center

the load on the Saddle of the Post. Release the

Handle so that ratchet catches on the Pawl.

7. Insert Locking Pin into the opening located next

to the Stop Tab. Secure the Locking Pin in place

by inserting the Safety Pin into the small hole

on the end of the Locking Pin. See Figure B.

Locking

8. Gently lower the vehicle with the floor jack. It may

drop down a very small amount until the ratchet

catches on the Pawl. Repeat on other side.

WARNING! TO PREVENT SERIOUS INJURY:

Set both the Jack Stands to the same height.

9. Determine if the vehicle is stable. If not, raise

the vehicle and reposition the Jack Stands.

4. Remove the Jack Stands. Use the floor jack

to safely lower the vehicle to the ground.

WARNING! TO PREVENT SERIOUS INJURY:

Do not use Jack Stands as a permanent stand for

the vehicle. Use them only while making repairs,

then immediately lower vehicle to the ground.

Safety Pin

Hole

Safety Pin

Figure B

Jack Stand