AirCube AC-6HYDROKIT-25G Kullanım Kılavuzu - Sayfa 5
Çiftlik Ekipmanları AirCube AC-6HYDROKIT-25G için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AirCube AC-6HYDROKIT-25G 8 sayfaları. Active oxigen grow system
Sayfayı Yazdır
SETTING UP THE GROW SYSTEM
Step 1: Set up Reservoir
8
Place the Brain Controller in front of the reservoir with
a timer facing away from the reservoir.
Measure and cut tubing to reach from the top of the
Brain Controller to the bottom of the inside of the
reservoir.
Assign a water pump as "Fill Pump", and place it at
the bottom of the reservoir. Connect one end of the
tubing to the Fill Pump.
Use the Tubing Puncture Tool to make a small hole in
the tubing inside of the reservoir near the top. Insert
the Vacuum
Break Barbed Elbow into the hole with the valve
facing downward to prevent water from siphoning.
Plug the Fill Pump into the outlet on the side of the
Brain Controller labeled "Fill Pump."
Step 2: Set up Brain Controller
There are 2 upper water level float valves that are on
an adjustable mount so the Brain Controller can be
used with different size pots. Adjust float valves to
preferred level. Ensure that the float valve does not
exceed the height of the top of any buckets.
Insert grommets into the 6 holes on the bottom of the
Brain Controller.
Insert 2 straight connectors into the front 2 grommets
on the bottom of the Brain Controller. Make sure
they are inserted all the way into the grommet. Insert
4 Stoppers into the rear 4 grommets. These can be
removed to add additional buckets.
Insert grommets into the holes on the Brain Controller
lid.
Insert straight connectors into the grommets on the
Brain Controller lid. [Change to insert connectors in
both holes]
9