Emeril Lagasse PPC772P Kullanıcı El Kitabı - Sayfa 13
Elektrikli Düdüklü Tencere Emeril Lagasse PPC772P için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Emeril Lagasse PPC772P 17 sayfaları.
Sayfayı Yazdır
Troubleshooting
Symptom
Possible Cause
Cannot open Pressure
Lid
Inner Lid is upside down
Pressure Lid does not
Inner Lid Rubber Gasket is not properly
lock
installed
Food level is too high to allow the lid to
close.
Cannot open Pressure
Float Valve and Pressure Release Valve
Lid after pressure is
are still raised
released
Pressure Lid incorrectly installed
Inner Lid not installed
Air escapes from the
rim of the Pressure Lid
Inner Lid Rubber Gasket not installed or
and pressure will not
incorrectly installed
increase
Food residue on Inner Lid Rubber Gasket
Inner Lid Rubber Gasket is damaged
or worn out
Food stuck on Float Valve Rubber Gasket
Air escapes from Float
Valve during operation
Float Valve Rubber Gasket not installed
or installed incorrectly
Float Valve Rubber Gasket is worn out
Appliance is not filled with enough food
or water
Float Valve does
not rise
Air is escaping from rim of Lid and/or
from Pressure Release Valve
Float Valve not assembled correctly
24
Emeril Lagasse Pressure Cooker Plus™ | Models: PPC771, PPC772 & PP772P
Solution
DO NOT FORCE OPEN.
Install the Inner Lid with the tab facing downward (ee INNER LID
ASSEMBLY in INSTRUCTIONS FOR PRESSURE LID ASSEMBLY, p. 14).
Press the middle hole in the Inner Lid onto the Pressure Lid's center
knob.
Remove some food so that it is not touching the Inner Lid.
Ensure the Pressure Release Valve is open. CAUTION: Hot steam may be
released during this process. DO NOT FORCE THE UNIT OPEN. Do not
place your face, hands, or body near the valve opening. Do not wrap your
arms or body around the Unit to try to open it. Allow the Unit to cool for
30 mins. before attempting to open again.
See ATTACHING LID in INSTRUCTIONS FOR PRESSURE COOKING,
p. 18.
Install Inner Lid (see INNER LID ASSEMBLY in INSTRUCTIONS FOR
PRESSURE LID ASSEMBLY, p. 14).
Install Inner Lid Rubber Gasket.
Clean Inner Lid Rubber Gasket.
Replace Inner Lid Rubber Gasket. Contact Customer Service (see the
back of the manual for contact information). for replacement parts.
Clean Float Valve Rubber Gasket
Install Inner Lid (see FLOAT VALVE AND RED PRESSURE INDICATOR
ASSEMBLY in INSTRUCTIONS FOR PRESSURE LID ASSEMBLY, p. 15).
Replace Float Valve Rubber Gasket. Contact Customer Service
for assistance (see the back of the manual for contact information).
Check recipe for proper quantities of solids and liquids.
Contact Customer Service for assistance (see the back of the manual
for contact information).
Float Valve should be able to move up and down, stopping only when
its Rubber Gasket meets the Lid interior. Ensure that its Rubber Gasket
is clean and the Float Valve can move freely.*
CONTINUED ON NEXT PAGE
Troubleshooting
Symptom
Possible Cause
Liquid spitting out of
Too much liquid in Unit
Float Valve
Unit turns off
Appliance is overheated
unexpectedly
Display reads "LID" and
Lid not positioned correctly or not fully
beeping sound occurs
closed
Lid does not open
Lid is put on incorrectly
*NOTE: If necessary to reassemble Float Valve, see FLOAT VALVE AND RED PRESSURE INDICATOR ASSEMBLY, p. 15.
DISPLAY ERROR INDICATOR
Error Code
Cause of Error
E1
Bottom sensor open
E2
Bottom sensor short circuit
E3
Unit has overheated
E4
Pressure switch malfunction
LID
Wrong lid
NOTE: DO NOT use or attempt to repair a malfunctioning appliance.
*See the back of the manual for Customer Service contact information.
Unit Specifications
Model
Supply
Rated
Number
Power
Power
PPC771
AC 120V ~60Hz
1000W
PPC772
AC 120V ~60Hz
1300W
PPC772P
AC 120V ~60Hz
1300W
Solution
Allow the cooking cycle to finish. Clean the Float Valve thoroughly. Use
less liquid in future recipes.
Unplug and let the Unit cool for 30 minutes in order to reset.
Adjust Lid by following ATTACHING LID in INSTRUCTIONS FOR
PRESSURE COOKING, p. 18.
NOTE: Non-pressure programs require a glass lid or an unlocked lid.
DO NOT FORCE LID OPEN. Unplug the Unit and allow to cool down for at
least 30 minutes. Then, attempt to remove the Lid.
Solution
Contact Customer Service*
Contact Customer Service*
Let the Unit cool down before use
Contact Customer Service*
Attach the correct lid before use
Capacity
Working
Safety Working
of Inner Pot
Pressure
Pressure
6 qt.
0–80 kPa
80–90 kPa
8 qt.
0–80 kPa
80–90 kPa
8 qt.
0–80 kPa
80–90 kPa
Emeril Lagasse Pressure Cooker Plus™ | Models:PPC771, PPC772 & PP772P
25