DaytonAudio IO8XTW Kullanıcı Kılavuzu - Sayfa 4

Konuşmacılar DaytonAudio IO8XTW için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DaytonAudio IO8XTW 8 sayfaları. 8" 70/100v 8 ohm indoor/ outdoor 2-way speaker with bass radiator

Sayfayı Yazdır

Speaker Cable

Don't compromise your sound quality by using thin, inexpensive speaker wire. We

recommend using high quality oxygen free copper two-conductor speaker cable.

For low-impedance applications (8 ohm) and runs less than 50 feet we recommend

16-gauge cable, and for longer runs we recommend 14 gauge or larger cable. (Wire

size is less important for 70-volt distributed audio applications but still may affect

performance.) Note that most municipalities require the use of CL2 rated speaker

cable for cable runs through walls and ceilings. Leave enough excess speaker cable

so you can stand comfortably on the floor or ladder while connecting the speaker

cable to the speakers. If mounting the speakers outdoors, you may wish to fill the

hole that the speaker wire passes through with a caulking material to prevent water

intrusion and air infiltration.

Speaker Connection

Remove about 4" of the cable jacket to expose the inner conductors. Strip ¼" of

insulation from each conductor. Remove the small plastic end cap from the back of

the speaker to expose the speaker wire connector. Remove the green speaker wire

connector and insert the speaker wire, observing speaker polarity. Using a small flat

head screw driver tighten the screws to secure the speaker wire. Plug the connector

back into the speaker and replace end cap.