GAI-Tronics Clean Phone 295W Manuel - Sayfa 10

Telefon GAI-Tronics Clean Phone 295W için çevrimiçi göz atın veya pdf Manuel indirin. GAI-Tronics Clean Phone 295W 19 sayfaları.

Model 295F and 295W Clean Phone™ Telephone

Remote Programming

Entering the Remote Programming Mode

Using a DTMF telephone, dial the unit's telephone number, wait for an answer tone, and enter the unit's

password. If you have not changed the password, enter 0 2 9 5. The password provides two benefits—

first, it allows Model 295 to be programmed from any DTMF telephone, and second, permits only

authorized personnel (those informed of the password) to reprogram the unit. If there is a security leak,

the password can be updated in a matter of seconds. The password can be changed through local or

remote programming.

The unit will answer the call (following the programmed number of rings), then send a short tone (answer

tone). The password must be entered within two seconds of hearing the answer tone. The remote

programming mode can only be entered when the entire password has been entered in the allotted time.

The unit will immediately hang up (disconnect) if the password is entered incorrectly. Failure to begin

entering the password after the answer tone will result in an intercom call.

The front panel light under the ON button will blink slowly, indicating that the unit is in the programming

mode. All front panel keys and incoming calls are ignored during the remote programming mode.

Exiting the Remote Programming Mode

There are three ways to exit the remote programming mode:

•

The unit detects the caller has hung up.

•

The caller enters * for at least two seconds.

•

The unit times out waiting for a digit (20 seconds).

In any event, the unit will go on-hook and extinguish the light under the ON button.

d:\standard ioms - current release\42004 instr. manuals\42004-146h.doc

11/05

Pub. 42004-146H

10 of 17

Page: