Greatneck 80154 Kullanıcı El Kitabı - Sayfa 5
Matkap Greatneck 80154 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Greatneck 80154 16 sayfaları. 3/8" drill
Sayfayı YazdırCheck for misalignment or binding of
moving parts, breakage of parts and any
other condition that may affect the tool's
operation. If damaged, have the tool
serviced before using. Many accidents
are caused by poorly maintained tools.
Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be
suitable for one tool may become
hazardous when used on another tool.
WARNING:
!
plug in your drill until you have carefully
read and understood this Owner's
Manual.
ALWAYS WEAR EYE PROTECTION
THAT CONFORMS WITH CSA
REQUIREMENTS or ANSI SAFETY
STANDARD Z87.1
FLYING DEBRIS can cause
permanent eye damage.
Prescription eyeglasses ARE
NOT a replacement for proper
eye protection.
Do not wear gloves, neckties or loose
clothing.
Do not drill material too small to be
securely held.
Always keep hands out of the path of
the drill bit. Avoid awkward hand positions
where a sudden slip could cause your hand
to move into the path of the drill bit.
POWER TOOL SAFETY
SPECIFIC SAFETY RULES
For your safety, do not
SAVE THESE INSTRUCTIONS FOR REFERENCE
SERVICE
Tool service must be performed only by
qualified personnel. Service or
maintenance performed by unqualified
personnel could result in risk of injury.
When servicing a tool, use only identical
replacement parts. Follow instructions
in the Maintenance section of this
manual. Use of unauthorized parts or
failure to follow Maintenance instructions
may create a risk of electric shock or injury.
Do not install or use any drill bit that
exceeds 7" (175 mm) in length or extends
more than 6" (150 mm) beyond the chuck
jaws. They can bend or break suddenly.
Before starting the operation, jog the
drill switch to make sure the drill bit does
not wobble or vibrate.
Do not use fly cutters or multiple-part
hole cutters, as they can come apart or
become unbalanced in use.
Make sure the spindle has come to a
complete stop before touching the chuck
or attempting to change the drill bit.
Secure workpiece. Use clamps or a vice
to hold the workpiece. It is safer than using
your hand and it frees both hands to
operate the tool.
Make sure there are no nails or foreign
objects in the part of the workpiece to be
drilled.
To avoid injury from accidental starting,
always remove the battery from the tool
before installing or removing a drill bit.
5