Greatneck 26006 Kullanıcı El Kitabı - Sayfa 10

Elektrikli Tornavida Greatneck 26006 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Greatneck 26006 15 sayfaları.

Sayfayı Yazdır

CHARGING THE BATTERY

Place the cordless screwdriver near a

110–120 V, 60 Hz electrical outlet.

Insert the battery charger plug (1) into

the charger receptacle (2) in the

handle of the cordless screwdriver (3)

(Fig. 1).

Plug the battery charger (4) into a

110–120 V 60 Hz wall receptacle.

NOTES:

a) The red indicator light (5) in the handle

will turn ON, indicating the battery is being

charged.

b) The red indicator light will remain ON

until the battery is fully charged.

c) A new battery or one that is completely

run down should be charged for 5 hours or

until the charger shuts down and the red

indicator light goes OFF. After normal use,

a battery should be fully charged in about 3

hours.

d) If the battery does not charge properly,

check to make sure the electrical outlet is

"live" and that the temperature range in the

work area is between 0–40° C (32–104° F).

Fig. 1

ASSEMBLY & OPERATION

INSTALLING SCREWDRIVER BITS

WARNING:

cordless screwdriver with your fingers

near the switch while changing

screwdriver bits. Accidentally touching

the switch may start the tool and

possibly cause an injury.

Insert the small end of the magnetic bit

holder (1) into the collet (2) of the tool

(Fig. 2).

NOTE: Push the bit holder as far as it

will go into the collet.

Select an appropriate screwdriver bit

that fits the head of the screw being

driven.

NOTES:

a) Use the largest size screwdriver bit

that will properly fit the screw head.

b) Make sure the screwdriver bit is in

good condition and is neither damaged

nor worn.

Insert the screwdriver bit (3) fully into

the large end of the magnetic bit

holder (4).

NOTE: Make sure the screwdriver bit

is fully inserted into the magnetic bit

holder until it is held in place by the

magnet.

Never hold the

Fig. 2