GAI-Tronics 298-103 Manuel - Sayfa 4

Acil Durum Telefonu GAI-Tronics 298-103 için çevrimiçi göz atın veya pdf Manuel indirin. GAI-Tronics 298-103 20 sayfaları. Externally powered emergency phones

Sayfayı Yazdır

S.M.A.R.T. E

XTERNALLY

Standard Operation

There are two types of telephones described in this manual. The first includes a single emergency push

button and the second includes an emergency push button, a call push button, and telephone keypad. The

operation of both is listed below.

Placing an Emergency Call from a S.M.A.R.T. Phone (All Models)

To place an emergency call:

1. Press the E

MERGENCY

number, typically a security office or 911.

2. As the factory default, the C

sound (i.e., "Hello, Security...").

3. As an alternate operation, the emergency phone can be configured* to require operator action to light

the C

ALL

ECEIVED

presses # (or *) to acknowledge the call and then the C

steady.

Placing a Non-Emergency Call (Models 294-103AL and 298-103 Only)

To place a non-emergency call:

1. Press the C

push button.

ALL

2. Wait for dial tone.

3. Use the keypad to dial the desired number.

4. At the end of the conversation, press the C

Receiving a Call

When a S.M.A.R.T. emergency telephone is called, the phone automatically goes off-hook and a

conversation can take place.

Disconnecting Calls

There are both manual and automatic methods included in the S.M.A.R.T. emergency telephones to

disconnect calls. The disconnect methods include the following:

•

To remotely disconnect of an emergency call, operator enters either the # # or *99 control command.

•

To manually disconnect an emergency call, press the E

disabled)*.

•

To manually disconnect a non-emergency call, press the C

•

To automatically disconnect;

All calls, loop current drop disconnect.

All calls, maximum call duration timeout (configurable from 1 minute to 4 ½ hours)

Emergency and incoming calls, call progress tones (dial tone, busy signal, fast busy (or reorder)

tone)

For factory defaults and available options, please refer to the Programming section of this manual.

*Contact the Service Center for details at 800-492-1212.

d:\standard ioms - current release\42004 instr. manuals\42004-377c.doc

08/06

ADA-C

OWERED

OMPLIANT

push button to place an immediate call to a preprogrammed emergency

ALL

ECEIVED

LED. If this mode is configured, the operator lifts the handset, and

HEN

ALL

MERGENCY

HONES

LED will light steady when the phone detects

HEN

ALL

ECEIVED

push button again to put the phone on-hook.

button after 15 seconds (can be

MERGENCY

button a second time.

ALL

PUB. 42004-377C

3 of 18

AGE

LED will light

HEN