emerio CG-123432 Kullanım Kılavuzu - Sayfa 5

ızgara emerio CG-123432 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. emerio CG-123432 16 sayfaları.

CG-123432

PARTS IDENTIFICATION

1. Handle

2. Securing latch

3. Indicator light

4. Upper housing

5. Upper cooking plate

6. Bottom cooking plate

7. Bottom housing

8. Oil drip tray

BEFORE INITIAL USE

1. Remove all packaging. The appliance is closed and locked by the securing latch on the side of the unit. Turn

the securing latch to unlock the appliance.

2. Wipe the surfaces and non-stick grill plates with a soft damp cloth, and then dry them.

DO NOT IMMERSE THE UNIT AND DO NOT RUN WATER DIRECTLY ON THE COOKING SURFACES.

3. Unwind the mains cable completely.

Note: When your grill is heated for the first time, it may emit slight smoke or odor. This is normal and harmless.

HOW TO USE

1. For best results, lightly coat the cooking plates with a little cooking oil or cooking spray.

2. Close the grill and plug it into the power socket. The appliance will start preheating and the indicator light

will illuminate.

3. It will take approximately 2-3 minutes to finish preheating, then the indicator light will turn off.

4. Open the grill and put the prepared ingredients on the bottom cooking plate. Close up the grill. The

indicator light will turn on again.

5. After cooking for 5-8 minutes, the indicator light will turn off again. Check if the food is golden brown.

Adjust the cooking time to suit the individual taste.

6. When cooking is finished, remove food by using a wooden or plastic spatula to protect the non-stick

coating of the cooking plates.

7. Disconnect the plug from the outlet after use and leave the appliance open to cool.

Note:

In order to speed up preheating, keep the plates of the appliance closed.

Defrost food before cooking.

CLEANING AND MAINTENANCE

1. Always unplug the appliance after use. Allow it to cool down before cleaning. The unit is easier to clean

when slightly warm. There is no need to disassemble the appliance for cleaning.

2. Clean the housing with a soft damp cloth and then dry it thoroughly.

3. Wipe the cooking plates with a soft cloth to remove the food residue. For baked food residue squeeze

some warm water mixed with detergent over the food residue and then clean with a non-abrasive plastic

scouring pad or place wet kitchen paper over the surface to moisten the food residue.

4. Remove and empty the oil drip tray. Wash it in warm soapy water. Avoid the use of scouring pads or harsh

detergents as they may damage the surface. Rinse and dry thoroughly with a clean, soft cloth and replace.

The oil drip tray is dishwasher safe.

- 4 -