Dynalite DDRC420FR Kullanım Kılavuzu - Sayfa 2

Kontrolör Dynalite DDRC420FR için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dynalite DDRC420FR 2 sayfaları. 4 x 20a relay controller

Sayfayı Yazdır

installation steps

1. Mount the device on a DIN rail inside an approved enclosure.

2. Calculate loads to ensure any channels are not overloaded, then connect loads to the output channels. The maximum loading of this device is as

follows:

Maximum Channel Load: 20A 230V AC

Total Box Load: 80A

Connect supply and load cables to each channel. Note that this device must have an individual supply circuit for each channel. The supply circuits

can be on any phase. Note that loads must have a Neutral (1 Phase or 3 Phase Star), Delta wiring is not supported.

3. Connect a single phase 0.1A feed to the supply terminals. This device must be earthed.

4. Connect data cables to the device as per the diagrams below.

5. If the Auxiliary input is to be used, connect a dry contact device in between the AUX and GND terminals. Keep cable runs bet ween the AUX

terminals and the dry contacts under two metres. The function of the Auxiliary input will need to be programmed at the time of commissioning.

connecting data cable

product specifications

Supply:

product specifications

Load Outputs:

Switching Device:

Supply Terminals:

Load Terminals:

IO:

DyNet DC Supply:

Preset Scenes:

Compliance:

Operating Environment:

Construction:

Dimensions:

Weight:

Dynalite manufactured by WMGD Pty Limited (ABN 33 097 246 921). Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: +61 2 8338 9899 Fax: + 61 2 8338 9333

100-240V 50/60Hz Single Phase at 0.25A

4 x Feed Thru Outputs at 20A per channel, maximum device load of 80A

Wiring topology: 1 Phase & Neutral and 3 Phase & Neutral Star. Delta not supported

Relay – 50A 230V AC inductive (5000W Lighting Load rated)

1 x Phase, 1 x Neutral, 1 x Earth, up to 1 x 4mm

IN, OUT for each channel, up to 1 x 4mm

1 x RS485 DyNet/DMX512 Serial port

1 x AUX programmable dry contact input

120mA (Supply for approx 6 panels)

170

CE, C-Tick

0° to 50°C ambient temperature

0% to 90% RH non-condensing

Polycarbonate plastic DIN rail mount

H 93mm x W 105mm x D 75mm

0.8kg

DDRC420FR Instruction Manual Rev G.doc

E-mail:

[email protected]

cable per terminal

. Specifications subject to change without notice.

Web: philips.com/dynalite