Activeforever SnowJoe Plus 322P Operatör El Kitabı - Sayfa 4

Kar Üfleyici Activeforever SnowJoe Plus 322P için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Activeforever SnowJoe Plus 322P 8 sayfaları. Snow thrower snowjoe

Sayfayı Yazdır

3. After sliding lower tube (B) inside the upper tube (A), line

up he screw holes on each tube (Figure 3).

Figure 3

A. Upper tube

B. Lower tube

4. Locate in the Parts Bag the slotted screw (C) and the

countersunk nut (D). Insert the screw through the aligned

holes in the upper and lower tubes and secure other end

with the nut.

Note: You may have to carefully move the wiring inside the

tube to one side if it blocks the path of the screw. (Use the

shipping wire provided; do not use a sharp tool.)

5. Loosen the adjustable handle and reposition until it reaches

the optimum length for the principal operator, then retighten

the bolt in Figure 4. (Readjust for each subsequent operator.)

Figure 4

E. Carriage Bolt

C. Slotted screw

D. Countersunk nut

Power Base Assembly

1. Position the power base (G) beneath the handle support

(H) as shown in Figure 5-2.

Figure 5-1

Figure 5-2

F. Power base connector

G. Power base

H. Handle support

2 Phillips-head screws

2. Pull the power base connector (F) out of the power base

(G). Push to snap together the connector on the handle

support to the power head!s connector; only one position

is possible, and they should fit without forcing (Figure 5-1).

3. Push the coupled connectors back into the motor compartment.

4. With the Snow Joe decal on the handle support (H) facing

you, line up the grooves in the handle support (H) with

the grooves in the power base, and slide together until

interlocked (Figure 5-3).

IMPORTANT:

If you encounter any resistance, STOP!

Possibly the wiring and connectors are out of position;

in that case, reinsert them with care into the motor

compartment and repeat step 4.

5. Locate two Phillips-head screws (I) in the Parts Bag. Insert

the first screw into the hole in back of the handle support

and turn until tight. Insert the second screw into second

hole and tighten (Figure 5-3).

Figure 5-3