Celestron C102-AZ Kullanım Kılavuzu - Sayfa 4

Teleskop Celestron C102-AZ için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Celestron C102-AZ 15 sayfaları. Refracting telescopes
Ayrıca Celestron C102-AZ için: Kullanım Kılavuzu (14 sayfalar)

Sayfayı Yazdır

Attaching the Slow

Motion Control Knobs

Figure 2-2

This illustration shows the

correct orientation of the

metal sleeve relative to the

slow motion shaft.

Attaching the Telescope

to the Mount

You are ready to attach the slow motion control knobs.

1. Retract the set screw on the metal sleeve of the slow motion control knobs

until it no longer extends into the inner diameter. The metal sleeve is on

the opposite end of the cable from the slow motion knob.

2. Slide the end of the metal sleeve over one of the two shafts protruding

from the mount. Make sure that the set screw on the metal sleeve is over

the flat part of the shaft (see figure 2-2).

The shaft on the right side of the telescope platform controls altitude

adjustments while the one on the left controls azimuth adjustments (see

figure 2-3).

3. Tighten the set screws to hold the slow motion control cables in place.

The optical tube is held to the mount with two mounting rings. On the bottom

of the mounting rings are square extrusions — one on each ring. This portion

of the ring slides over part of the mounting platform to hold the telescope in

place.

1. Slightly loosen the screws that hold the mounting rings on the telescope in

place.

2. Slide the rings apart so that each is toward a different end of the tele-

scope. Ideally, the mounting rings should be slightly farther apart than the

length of the mounting platform.

Figure 2-3