Hiddn SafeDisk Kurulum Kılavuzu - Sayfa 2

Depolama Hiddn SafeDisk için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Hiddn SafeDisk 13 sayfaları.

1. Introduction

This document will explain what is delivered, how units are initialized (loaded with certificates) and some

alternatives for installing an operating system.

The Card Management System (CMS) Administrator is responsible for providing the required smart cards for

initialization of the Hiddn SafeDisk units. For guidance on how to use the CMS to program CO Cards, please see

the CMS manual.

When working with the Hiddn SafeDisk product, it is important to remember that once the PIN/password is

accepted and data encryption keys are loaded, the keys stay active until powered off. This means the keys will

survive a reboot, which might occur frequently during installation of operating system or restoring backups.

However, the slightest loss of power to the drive will cause the encryption keys to be cleared.

2. Physical Installation of the Hiddn SafeDisk

Prior to initializing the Hiddn SafeDisk, the original hard drive of the computer must be removed and replaced

with the Hiddn SafeDisk unit. Please consult your computer manufacturer's manual for instructions on how to

remove and replace hard drives.

1. Make sure the computer is powered off

2. Remove the hard drive cover from the outside of the computer

3. Remove the original hard drive from the computer

4. Move any rubber or plastic parts from the original drive to the Hiddn SafeDisk

5. Gently insert the Hiddn SafeDisk unit

6. Press firmly at the end of the Hiddn SafeDisk unit to ensure that the connector is properly inserted.

7. Reattach the hard drive cover and fasten any screws

The physical installation is now completed.

3. BIOS/UEFI Configuration

Before the Hiddn SafeDisk is ready for use you need to ensure that the SATA mode setting is correct.

1. Power on your computer

2. Enter BIOS/UEFI, usually by pressing F2.

3. If "Secure Boot" option is present, disable it.

4. If "SATA mode" option is present, set it to AHCI. RAID mode is not supported. If it fails, try IDE. IDE mode

might also be called "Native", "Legacy" or "Compatibility".

5. Save settings and EXIT

If you experience problems, try upgrading BIOS to latest version then load default settings and start over.

Page 2 of 12

Hiddn Security AS

Hiddn Safedisk Installation Manual LT02-IM-01-ENG-24.04.2018

http://www.hiddn.no