Gainsborough H328 Manuel - Sayfa 2

Dış Mekan Çeşmesi Gainsborough H328 için çevrimiçi göz atın veya pdf Manuel indirin. Gainsborough H328 3 sayfaları. Solar elephant fountain

Solar Elephant Fountain

Please read and retain these instructions for future reference

To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden

stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first

then gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the

ornament housing containing the actual LED light.

Find an ideal Place for the Solar Light.

Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of

hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed

in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the

light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from

coming on, or cause it to turn off automatically

INSTALLATION:

1. Attach the pump to the solar panel before use, plug the sprinkler head or hose into the outlet of the

pump. Make sure the water level covers the pump, but is lower than the sprinkler head.

2. Plug the power line of the pump into the plug of the solar panel, and then fasten.

3. Position the solar panel in full sun to optimally run the pump, the backup battery will be charged from

the solar panel during normal operation and automatically run the pump without direct sunshine.

4. If required the pump can be run by the battery in times of low sunlight. Turn on the switch at located at

the back of the solar panel, if the battery is fully charged the pump will start to work immediately.

CHARGING AND OPERATION

1. Turn the switch, which is located under the solar panel, to "ON" position and

the battery will work automatically. Charge the solar product by placing it

under direct sunlight for at least 8 hours. Recommend longer charging time

for the first use. If the switch is "OFF" the battery will not work, solar panel

ensures the pump works directly.

2. The light will work automatically.

The pump/fountain function will work best when fully

HOW TO USE:

charged under direct sunlight.

power the fountain water and light for a minimum of a few hours.

Care and Maintenance Recommendations

1. Clean solar panel with a soft sponge every couple of weeks.

2. Make sure all connectors are still tight and no water getting in.

3. Keep the water clean during the summer keep topping up every 3 or 4 days with clean water.

4. Clean any pipes every month stop any build-up of algae which could put an extra pressure on your

pump.

5. Take out any foreign body around the pump and keep clean solar product.

6. Always make sure there is enough water for the pump to work otherwise you could damage the pump.

H328

When there is no sun, the built-in batteries will

Instructions for Use

v001: 23/10/20