Gainsborough TRILOCK G1 Series Kurulum Talimatları - Sayfa 3

Kilitler tarafından Gainsborough TRILOCK G1 Series için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Gainsborough TRILOCK G1 Series 4 sayfaları. Eclipse dummy, suits 35mm to 45mm door thickness
Ayrıca Gainsborough TRILOCK G1 Series için: Kurulum Talimatları (2 sayfalar)

Sayfayı Yazdır

Installation Instructions for 8955 BB Series Omni Trilock

Twin Pull Handle Version - Suits 35mm to 45mm door thickness

Step 10

• For single cylinder applications install internal

turnbutton now by tightening grub-screw onto

protruding shaft.

grub-screw

allen key

Step 13

Fixing of double pull handle

Note: Suitable for solid doors only

• Check and make sure that the inside & outside faceplates are lined up

straight and square with the door.

• Once the desired position of the inside & outside faceplate has been

confirmed, mark the centre of the hole at the top of the faceplate and

proceed to drill a suitable hole. Note: When drilling the hole drill hole

from both sides of the door with a 9mm drill bit.

• On the inside faceplate, hold the optional rectangular plastic washer

centred over the hole against the door surface.

• Then hold the unthreaded bush onto the outside faceplate, ensuring

the larger section of the bush, as marked 'A' in illustration, is facing

the door.

• Then, from the same side, install the suitable M8 screw through the

bush and optional plastic washer (if used) and through the door.

• Then, from the outside faceplate fit the threaded bush

• Tighten M8 screw securely with suitable screwdriver.

• Place the pull handle over top of 2 mounting bushes.

• Line up the pull handle so that it is lined up straight and square.

Insert the grub screws and tighten with allen key provided

single

pull handle

grub screw

Note: Ensure larger section of

threaded bush, as marked 'A' above,

is facing door

NOTE: • carefully follow these instructions when installing.

• do not overtighten screws.

• use of power driver is not recommended.

• fully remove the Trilock prior to painting the door

to avoid harming the product's finish.

M8 x 82mm bolt

un-threaded

bush

Step 11

All door seals must be fitted prior to fitting

strike plate.

• Position the door so that the centrepoint of the

strike plate can be marked on door frame.

reinforced

strike plate

door

frame

anti-rattle tab

25mm dia.

plastic washer

timber

door

threaded

bush

rosette

• Mark and drill a 25mm (1") hole to a depth of 25mm

(1"), at a corresponding height to the bolt.

• Mark and chisel recesses for strike plate and optional

reinforced strike plate.

• Screw into position using 4 wood screws as supplied.

Note: 2 larger screws should be used on reinforced

strike plate as illustrated.

Door Adjustment

1 When door is closed using finger pressure, ensure

bolt is latching into strike plate.

2 If door is rattling when in latched position. Open door,

remove strike plate & adjust anti-rattle tab & refit strike

plate to door frame. Repeat check 1.

single

pull handle

grub screw

pull handle

support