80TAPE LIMBO III-COMPACT Manuel

Kayıt Ekipmanları 80TAPE LIMBO III-COMPACT için çevrimiçi göz atın veya pdf Manuel indirin. 80TAPE LIMBO III-COMPACT 3 sayfaları.

IN LIMBO III - COMPACT MANUAL

POWER SUPPLY NOTES:

Voltage: 9V DC (negative tip - standard Boss style 2.1mm connector)

Typical current draw: 120mA (recommended 200mA power supply)

CV Input range: 0 to +5V

EXT tap: Active LOW (Expects to be pulled to GND)

Where possible avoid daisy chaining this unit to avoid interfernce.

Changing subdivision:

Hold the tap tempo switch for one second then turn

the DELAY control a quarter turn in any direction.

Next, move the dial to the desired subdivision as

shown on the right release the tap tempo button

when in place to set. The setting will be saved and

recalled for next use.

Con gure for Ext. Tap OR Expression mode:

1) Power the unit o then con gure the internal dip

switches as shown below for the appropriate settings. The

bottom case needs to be opened and with a small

screwdriver push the white knobs into position.

2) Now hold the tap tempo button, wait a couple of

settings then turn the M.Speed control to the appropriate

setting. Release the tap tempo button and the setting will

be saved.

Make sure both steps have been completed.

Ext. tap

mode

Setting the regen swell amount:

Hold the tap tempo and then turn the Regen control to the desired position (hint - play a note to see how it

currently sounds). Once at the desired position release the tap tempo and the setting will be saved.

To test, Dial the Regen control back a little and then hold the tap tempo button again. Automatically the Regen

control is transitioned to the saved setting, once the tap is released it will return to normal. The transistion takes

about 500ms to ramp up.

Expression/

CV mode

M.SPEED

For Expression/CV mode.

For Ext tap mode.

80TAPE FX

Dunedin, New Zealand

DELAY

DIP