DB Drive A7PRO 2.5K Kullanıcı Kılavuzu - Sayfa 4

Amplifikatör DB Drive A7PRO 2.5K için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DB Drive A7PRO 2.5K 6 sayfaları. Proaudio-class d mono amplifier

Sayfayı Yazdır

WORLD RECORD BREAKING TECHNOLOGY

GND ( GROUND CONNECTION )

Locate a secure grounding connection as close as possible. Make sure the location is clean and provides a direct

electrical connection to the frame of the vehicle.

Connect one end of a short piece of the same gauge cable as the power cable to the grounding point.

Run the one end of the cable to the grounding point. Run the other end of the cable to the mounting location.

Connect the ground cable to the screw terminal labeled as GND.

REM ( REMOTE CONNECTION )

Run a remote turn on cable from the headunit's remote swithed +12V output.

AMPLIFIER +12V, GROUND, REMOTE CONNECTION DIAGRAM

Remote turn on

3-4. SPEAKER CONNECTION

DB Drive recommends to use minimum 12 gauge speaker connecting cables. Run 12 gauge speaker

connecting cables from your speakers to amplifier's mounting location.

Keep speaker cables away from the power cables and amplifier's input cables. Use grommets anywhere

the cables have to pass through the holes in the metal frame or sheet metal. Connect to the speakers

according to the type of terminals on each speaker. Strip 3/8" of insulation from the end of each cable and

twist the cables strands together tightly. Make sure there are no stray strands that might touch other cables

or terminals and cause a short circuit.

Crimp spade lugs over the cable ends or tin the ends with solder to provide a secure termination.

Connect the cable ends to amplifier as speaker system diagram.

CLASS D MONO AMPLIFIERS' SPEAKER CONNECTION DIAGRAM 1.

8 ~ 1 ohms