Hideaway Deluxe Series Nasıl Bakım Yapılır - Sayfa 2
İç Mekan Mobilyaları Hideaway Deluxe Series için çevrimiçi göz atın veya pdf Nasıl Bakım Yapılır indirin. Hideaway Deluxe Series 2 sayfaları. Range floor mount
Ayrıca Hideaway Deluxe Series için: Kurulum Talimatları (2 sayfalar), Kurulum Talimatları (2 sayfalar)
Sayfayı YazdırPush firmly on the back of the unit to ensure the
lid clears the hooks located on the right and left
hand sides of top mounting panel
Hook
Front lid support
The unit should look like this with the friction-
fitted lid removed (Soft Close model shown
with door bracket removed for illustration).
Replacement parts and compostable bin liners for your Hideaway Bin can also
be purchased via our website!
Questions? See the FAQ section of our website
NEW ZEALAND
09 426 7456 / [email protected] / www.hideawaybins.co.nz
AUSTRALIA
1800 042 642 / [email protected] / www.hideawaybins.com.au
How to remove the friction-fitted lid from a Deluxe
or Soft Close Bin (for cleaning)
NOTE: Compact Bin models DO NOT have
removable lids.
• If you have a Deluxe model: Remove and separate the runners as
explained in the above instructions.
• If you have a Soft Close model: remove the buckets from your unit. The
runners on the Soft Close range do not seperate.
• Both ranges: you need to clear the hooks at the back of the lid. Place
your hand at the back of the lid and then push up and pull forward in the
same motion. This will release the lid. Remove the lid clear of the main
unit. This will then allow you to clean the lid.
How to reinstall the friction-fitted lid into your
Deluxe or Soft Close Bin
• Rest the foam on top of the friction-fitted lid. NOTE: the plastic sleeve
stays on the foam to protect it.
• Slide the friction-fitted lid and foam inside the top mounting panel,
stopping just before the rear hooks. NOTE: the large fold on the friction-
fitted lid sits at the front of the unit, the rear of the lid has the slots which
reconnect with the hooks located on the top mounting panel.
• Check that the foam is behind the front lid support.
• Simultaneously, with one hand, push firmly up on the back of the
friction-fitted lid, push the lid above the hooks and drop into location.
Whilst this is happening, with the other hand push the front of the lid
upwards to ensure it rests on the front lid support - located at the front of
the top mounting panel.
• The lid should move up and down a small amount, with ease indicating
correct installation.
•
If you have a Deluxe model:
Lid coming free
above instructions.
of hook
reattach the runners as explained in the