Hideaway Beds Studio Montaj Talimatları Kılavuzu - Sayfa 7

İç Mekan Mobilyaları Hideaway Beds Studio için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. Hideaway Beds Studio 7 sayfaları. Universal table/desk for all sizes of panel wall beds

Sayfayı Yazdır
STEP 5: Install Desk/Table to Bed Face Panel
1.
Raise the Desk and hold it in the UP position (where it will be when mounted to the Bed Face).
2.
Hold the Desk against the Bed Face, making sure that the Desk is level both front to back and end to
end.
3.
Using a pencil, lightly mark the Hinge locations and heights on the Bed Face Panel. Mark the height
of the top edge of the Riser.
4.
Lower the Desk to the floor and detach the Legs from the Pivot Brackets.
5.
Mount the Hinge Mate Clips to the Bed Face to assist in mounting and leveling the desk. Attach the
Clips so the clip shelves are 1.5" (38mm) below the pencil mark of the top edge of the Riser. Check
the level line between all three Clips to ensure that the desk will be level. Secure all three Hinge
Clips. See Drawing #5.
6.
Bring the Studio Desk/Table back up to the Bed Face and seat the long Hinge leaves in the Hinge
Clips. Screw the long leaves of the Hinges to the Bed Face. Recheck levelness in all directions.
7.
Re-attach the Legs and snug up both upper and lower pivots. It is not necessary to remove Hinge
Clips as they are out of sight after the installation.
Drawing #5: Hinge Clips
STEP 6: Test
1.
Operate the Desk/Table slowly.
2.
Double check the levels.
3.
Make sure that all End Caps are installed.
Hinge
Hinge Clip
Long Hinge
Leaf
Clip Shelf
Riser
Hinge Clip
1.5"
38mm
Bed
Face
7.