DynaMetric TMP-636S Talimatlar - Sayfa 4

Ölçüm Cihazları DynaMetric TMP-636S için çevrimiçi göz atın veya pdf Talimatlar indirin. DynaMetric TMP-636S 4 sayfaları. Telephone transmit & receive patch

Sayfayı Yazdır

INSTRUCTIONS

TMP-636S Telephone Transmit & Receive Patch

For Use with Sound Card with PC Speakers

Sound Recorder

RECORD - Make a phone call, and push the Record

button (red circle) on the Sound Recorder. As you talk into

the phone, your voice will be visible in the Sound Recorder

window.

Adjust the Microphone Volume control as

necessary.

If it is set too low, the display in Sound

Recorder will show that it is low. If it is too high, it will

sound distorted during playback. In some versions of the

Record Volume Control, there is a button marked

'Advanced' in the Microphone section, which may provide

a Mic Boost function. Use this only if necessary. Push the Stop button (black square) to end the

recording. Sound Recorder's maximum recording time is 1 minute.

PLAYBACK – During a phone call, push Play (black arrow) to begin playback. Adjust the Volume

Control and Wave volume controls in the Playback Volume Control panel to get the best sound. If the

playback is distorted even after adjusting both the Wave and Volume, turn down the Mic Volume

control during recording.

The recording can be saved with the SAVE command in the Sound

Recorder 'File' menu.

FEEDBACK – Feedback can occur when the output signal from your sound card goes through the

TMP-636S to your phone mic, the phone transfers the signal to the handset earphone, which is picked

up by the TMP-636S and sent back to the sound card Mic input. If the Mic is not Muted in the

Playback Volume Control, then the signal goes around and around the loop. Feedback may be

audible (a loud tone or squeal), or inaudible and just cause noise, distortion and/or very low record

levels. Always make sure that the Mic is muted in the Playback Volume control to avoid feedback.

FOR LEGAL USE ONLY

6-10-05

www.DynaMetric.com

Page 4 of 4