8BitMods MemCard PRO Kullanıcı Kılavuzu - Sayfa 13
Depolama 8BitMods MemCard PRO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 8BitMods MemCard PRO 15 sayfaları.
Sayfayı Yazdır
FAQs & Troubleshooting
1. What file system formats does MemCard PRO support?
MemCard PRO only supports a simple MBR partition
scheme with a FAT32 or exFat volume. Please use the
official SD Card Formatter software for maximum
compatibility
2. Can MemCard PRO work without an SD card?
MemCard PRO will not work without a microSD card
plugged in.
3. What consoles does MemCard PRO support?
MemCard PRO has only been tested with the original Sony
PlayStation, Sony PSone and PlayStation 2 Consoles.
PlayStation 2 Slim consoles and the PS3 Adapters do not
work with MemCard PRO without modifications to these
consoles.
4. What VMC card formats does MemCard PRO generate /
support?
MemCard PRO can only create and use raw Memory Card
images. The file extension used is ".mcd" and the files have
no extra headers. Any header-less memory card image can
be used with MemCard PRO, as long as it is properly
named and has the .mcd extension.
5. Can I use my MemCard PRO saves with an emulator /
Can I use my emulator saves with MemCard PRO?
Yes! Both use cases are possible as long as the files used
have no extra headers. An easy way to check if your
memory card file will work with MemCard PRO is to check
its actual size. The file should be exactly 131,072 bytes
long.
6. The Gamepad combos are not working!
MemCard PRO can only detect gamepads button presses
from the controller connected to the same port as the card.
I.e. if you've plugged your MemCard PRO to Slot 1, the
controller should be plugged in to Slot 1 as well for
MemCard PRO to detect the button presses.
7. I have connected MemCard PRO to my local wireless
network, but I can't open the WebUI page!
A few different causes can lead to this, with the most
common being that the remote device is not on the same
subnet as MemCard PRO. You should connected to the
same network as MemCard PRO in order to access its
WebUI. Another reason is that MemCard PRO was
unsuccessful connecting to your wireless network. You can
try moving the console and MemCard PRO closer to your
router if that's the case. If you don't see an IP address on
MemCard PRO when holding the left physical button, then
the card could not connect to the WiFi. If that's the case,
MemCard PRO will default back to an Access Point after the
next power cycle, and you can attempt the WiFi setup
again.
Page 13