DB Research DB Drive Euphoria EPS68 Kullanıcı Kılavuzu - Sayfa 7

Subwoofer DB Research DB Drive Euphoria EPS68 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DB Research DB Drive Euphoria EPS68 8 sayfaları. 6x8" low profile amplified subwoofer

Sayfayı Yazdır

Troubleshooting

If you experience operation or performance problems with this product, compare your

installation with the electrical wiring diagram on the previous pages. If problems persist,

read the following troubleshooting tips which may help eliminate the problems.

SYMPTOM

Amplifier will not

power up.

Protection LED

comes on when

amplifier is

powered up

No output.

Low output.

High hiss in the

sound.

Squealing noise

is present.

Distorted sound.

Amplifier gets

very hot.

Engine noise

(static type)

Engine noise

(alternator whine)

POSSIBLE REMEDY

Check to make sure you have a good ground connection.

Check that the Remote Input (Turn-On) has at least 5VDC.

Check that there is battery power on the (+) terminal.

Check that there is at least 12v.

Check all fuse, replace if necessary.

Make sure that the Protection LED is not illuminated. If it is lit, shut off

the amplifier briefly, and then repower it.

Check for short circuits on speaker leads.

Turn down the volume control on the head unit to prevent overdriving.

Remote speaker leads, and reset the amplifier. If the Protection LED still

comes on, then the amplifier is faulty and needs servicing.

Check that all fuses are OK.

Check that unit is properly grounded.

Check that the Remote Input (Turn-On) has at least 5VDC.

Check that the RCA audio cables are plugged into the proper inputs.

Check all speaker wiring.

Reset the Level Control.

Check the Crossover Control settings.

Disconnect all RCA inputs to the power sub's control panel. If the hiss

disappears, then plug in the component driving the amplifier and unplug

its inputs. If the hiss disappears at this point, go on until the faulty/noisy

component is found.

It is best to set the amplifier's input level control as low as possible. The

best subjective signal-to-noise ratio is achieved in this manner. Try to

set the head unit as high as possible (without distortion) and the amp

input level as low as possible.

Check for improperly grounded RCA interconnects.

Check that the Input Level Control is set to match the signal level of the

head unit. Always try to set the Input Level as low possible.

Check that all crossover frequencies are properly set.

Check for short circuits on the speaker leads.

Check that the minimum speaker impedance for the amp model is correct.

Check that there is good air circulation around the amp. In some

applications, it may be necessary to add and external cooling fan.

This is usually caused by poor quality RCA cables, which can pick up

radiated noise. Use only the best quality cables, and route them away

from power cables.

Check that the RCA grounds are not shorted to the vehicle chassis

Check that the head unit is properly grounded.