Dynamic nxt Back Kurulum ve Kullanım Kılavuzu - Sayfa 17

Tekerlekli Sandalye Dynamic nxt Back için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Dynamic nxt Back 20 sayfaları.

Sayfayı Yazdır

üFit

CUSTOMIZABLE CONTOUR SUPPORT BACK

™

1. Customization

üCube

sets can be removed

™

completely, or cut for greater

customization. To remove/cut,

first unzip both zipper pulls on

the cover and fold the front of

the cover down. Remove the

center foam overlay, to expose

the üCube

. To remove the

™

üCube

, grasp the cube set by

™

the darker coloured closed cell

foam base and gently pull up –

the cube will release from the

back shell.

If cutting, cut the üCube

shell by aligning the studs (white pins on the underside of the üCube

the holes and pushing back into place until an audible click is heard. Once

all desired customization is complete, re-install the center foam overlay and

zip-up the cover.

2. Installing Head Support

To install a head support on the üFit

you must remove the cover fabric that

overlays the slots which the

head support is installed

in. Coneveniently, there

is a punched template to

follow. Simply connect

the ends of the existing

cuts with scissors or a

knife to remove the

rectangle of fabric.

Next remove the back cover and then the üCube

around the mounting slots. Install the mounting hardware and adjust the

angle as desired by rotating the bracket slightly either clockwise or counter

clockwise.

Reassemble the üCube

through the hole cut into the cover.

once it has been removed, and re-install on back

™

and cover ensuring the mounting hardware fits

™

that are in the area

™

) with

™