Hidro-Water XENA 10.1 Kullanıcı ve Montajcı Kılavuzu - Sayfa 6

Su Filtrasyon Sistemleri Hidro-Water XENA 10.1 için çevrimiçi göz atın veya pdf Kullanıcı ve Montajcı Kılavuzu indirin. Hidro-Water XENA 10.1 13 sayfaları.

Sayfayı Yazdır

d. Connect the ⅜" tube (figure 6) to the outlet of the pressure reducer (figure 15); to do so,

you must remove the blue safety clip on the outlet and insert the tube fully. Once you

have inserted the tube, put the ⅜" safety clip back on (the pressure reducer has a label

with an arrow which indicates the water flow).

e. The other end of the ⅜" should be connected to the inlet of the WATER STOP Antileak

system (figure 13) where it is marked "IN", inserting it fully. Once it is inserted, replace

the ⅜" security clip (figure 14).

The WATER STOP Antileak system (Figure 13)

must be fixed to the base of the unit where you're

installing the osmosis system, fixing it with the

adhesives supplied.

g. Once you have fixed the WATER STOP Antileak

system in the chosen place, you must connect the ⅜"

tube to the outlet of the Antileak system (figure 13),

marked "OUT", inserting it fully. Once it is inserted,

replace the ⅜" security clip (figure 14).

h. The other end of the ⅜" tube must be connected to

the inlet of the XENA 10.1 osmosis system (figure 1),

where it is marked "ENTRADA". To do so, you must

unscrew the inlet elbow nut on the osmosis system

and insert the ⅜" tube through the nut and into the

system, having previously inserted a ⅜" plastic insert

(figure 11). Screw the nut back on the system.

Screw the faucet adapter (Figure-12) to the faucet.

Then connect ⅜" tube (Figure-6) to the faucet adapter.

Insert it fully. Once inserted put on the ⅜" security clip.

MA-EN-OSMOSIS XENA10.1-RO-0220-22-FLC-21-V01.0

The other end of the ⅜" tube must be inserted

through the nut on the outlet of the post filter marked

"GRIFO". Screw the nut back on having previously

insert-ed a ⅜" plastic insert (figure 11).

k. Unscrew the nut on the relief valve which is marked

"DESAGÜE". Insert the ¼" tube (figure 5) through

the nut and place a ¼" plastic insert (figure 10) on

the end. Screw the nut back on.

The other end of the ¼" tube must be inserted through

the nut on the drain clamp (figure 7). After inserting

the corresponding ¼" plastic insert, screw the nut

back on the drain clamp.

m. Connect the XENA 10.1 osmosis system's plug into

the electricity supply of 220-240V.

Here is a diagram of how the system should be installed.

MA-EN-OSMOSIS XENA10.1-RO-0220-22-FLC-21-V01.0