ActivePure B1013U Manuel - Sayfa 11

Hava Temizleyici ActivePure B1013U için çevrimiçi göz atın veya pdf Manuel indirin. ActivePure B1013U 16 sayfaları.

TROUBLESHOOTING GUIDE

This unit must be installed and serviced by a licensed HVAC contractor or

electrician. Failure to do so will void the warrant of the product.

Caution

• UV Light in operation; disconnect unit from power cord before servicing; failure

to follow warnings may result in severe eye damage

• Live voltage may be present

WARNING

TROUBLESHOOTING GUIDE FOR ACTIVEPURE

Tools Required:

• 1/4 Nut Driver

• Phillips Head Screwdriver

• Multimeter

• Small Flat Head Screwdriver

• Flashlight

1. Check the incoming voltage by unplugging the power cord from the side of the ActivePure

Guardian I and placing one probe on the outside of the plug and the other on the inside of the

plug. Voltage measurement should read 18-32VAC. If no voltage is present, replace the transformer

supplying power to the ActivePure

2. Leave unit attached to ducting. Remove (4) Phillips head screws from the cover of the unit. Remove

the cover. Unplug the black and white wires from the ballast. Check incoming voltage by placing

Multimeter probes on the two exposed wires. Voltage measurement should be between 18-32VAC.

If there is no voltage reading, power is not supplied to the unit. Check power source and verify

Induct Safety Switch is fully depressed. Safety switch plunger is located underneath the unit and is

depressed when unit is secured to mounting plate.

3. Re-plug the black and white wires to the ballast.

4. Remove unit from the duct by taking off the (4) 11/32 thumb

nuts that secure the unit to the mounting plate.

5. Remove the (2) Phillips head screws that hold the cell

assembly in place. Remove the UV lamp from the 4-pin

connector by placing a small flat head screwdriver between

the 4-pin connector and the UV lamp base. Gently pry and

lift up on the Cell until the UV lamp is unseated from the

4-pin connector, remove the Cell Assembly.

INDUCT GUARDIAN I (Model: B1013U)

Induct Guardian I.

Induct