Dynamic Engineering PCI2PMC Kullanıcı Kılavuzu - Sayfa 7

PCI Kart Dynamic Engineering PCI2PMC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dynamic Engineering PCI2PMC 15 sayfaları. Pci single slot pmc compatible carrier use your pmc in a pc

Sayfayı Yazdır

J6 and J7 control the PrPMC clock options. Installed with –M option.

OPN OPN

PCI CLK VIA PLL TO PMC – standard non –M signal path.

SHNT SHNT

OSC TO BP & PMC BIPASS PLL

SHNT OPN

OSC TO BP & PMC USING PLL

OPN SHNT

PMC DRIVING CLOCK TO BP

J9 is installed when the –M option is requested. J9 is a two pin header. When a shunt

is installed the 1KΩ resistor provides a pull-down. When open a 10KΩ resistor provides

the pull-up. The installed PrPMC can usually override either setting after power-up

using software.

PCI2PMC is a product consisting of a PCB and added components. The components

can be swapped or left off to create different versions.

The standard version of the board is called "PCI2PMC" and comes with a complete 64

bit PCI path to support 32 and / or 64 bit operation at 33 and / or 66 MHz. The PMC

may have IO through its bezel or via Pn4 or both. The Bezel IO is supported via the

PCI rear IO port. The Pn4 IO is supported with either a DIN or SCSI connector. The

DIN connector is standard and the –SCSI option swaps the DIN for the SCSI.

The PCI2PMC–ME version removes the Upper part of the PCI bus and the rear IO

leaving the primary 32 bit PCI path and PMC Bezel IO. This version is usually provided

with the –HC option to remove the regulator and FET's etc. to provide a hardwired PCI

3.3V sourced board.

The PCI2PMC, PCI2PMC-SCSI, and PCI2PMC-ME-HC are stocked items. Other

combinations are built to order. Please see the last page for more ordering options.

Embedded Solutions

Page 7