ActivePure Induct Guardian I Manuel - Sayfa 7

Kontrol Ünitesi ActivePure Induct Guardian I için çevrimiçi göz atın veya pdf Manuel indirin. ActivePure Induct Guardian I 16 sayfaları.

FIBERGLASS DUCTWORK INSTALLATION (CONTINUED)

5. Remove backing from the mounting

plate adhesive gasket.

7. Insert (4) toggle bolts into 3/8" holes

in duct. Be sure toggle anchors open

after inserting.

9. Insert unit into opening. Be sure the air

will pass through the ActivePure

honeycomb matrix.

NOTE: Unit requires continuous power. Do not install where power to the unit will be cycled on and off.

6. Insert (4) 2" Threaded bolts into screw

8. Center large opening in the mounting plate

over 3.5" opening in duct and press plate

to duct. The adhesive gasket will hold the

mounting plate into place. Tighten toggle

bolts - DO NOT OVERTIGHTEN.

10. Secure the unit to the mounting plate

Cell

holes at corners of mounting plate.

Attach (4) toggle bolt anchors to ends of

threaded bolts.

with four (4) thumb nuts.

Stud