Celestron HomeCast DELUXE Kullanıcı Kılavuzu - Sayfa 4

Hava İstasyonu Celestron HomeCast DELUXE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Celestron HomeCast DELUXE 7 sayfaları. Weather station with remote sensor

Sayfayı Yazdır

GETTING STARTED

Main Unit:
•
Open main unit battery compartment cover (C2).
•
Insert 3 x AA batteries and replace the cover.
•
Use a paper clip or similar small pin to press the RESET button (B12) on the rear of the main unit, the unit is
now ready for use.
Outdoor Sensor:
•
Open the battery Cover (D4) of sensor. Insert 2 x AAA batteries and replace the cover.
Installation:
•
Place the main Unit on any flat surface using the hinge out stand (C3), or wall mount using the wall mount
hole (C1).
•
Place the remote sensor outside. It can be mounted in a similar way using the hinge out stand (D9) or wall
mount hole (D5).
Note: Transmissions between the main unit and sensor can reach up to 30m barring any interfering obstacles such as
buildings, trees, vehicles, high voltage lines, etc.

WEATHER FORECAST FUNCTION

•
Your personal weather station displays an animation showing the current weather status.
•
To pre-set the status setting, press and hold the WEATHER button (B7) for 3 seconds. The Weather Forecast icon (A2) will flash.
•
To change the current weather status animation press the - (B9) or + (B8) buttons.
•
Press the WEATHER button (B7) again to confirm your choice.
Note: The current weather status should be reset if there is a change of altitude.
There are 5 different weather status animations in the weather forecast:
Freezing or Snow
Rain
BAROMETRIC PRESSURE READING
Barometric Trend Pointer: The arrow displayed on the LCD (A1) indicates the Barometric Pressure "trend".
Indicating the barometric
pressure trend is rising
Absolute/ Relative Air Pressure:
•
Display: Press the ABSOLUTE/ RELATIVE button (B10) to change display from the Absolute Pressure icon "ABS" or
Relative Pressure icon "REL".
•
Set Benchmark of Relative Pressure: When viewing relative pressure, hold the ABSOLUTE/ RELATIVE button (B10)
for 3 seconds, press the - (B9) or + (B8) button to adjust; press the ABSOLUTE/ RELATIVE button (B10) to confirm.
You can set this pressure based on your local weather forecast.
Past Hour Air Pressure (History) Reading:
•
Press the HISTORY button (B7) to view the past 12 hour's barometric pressure history. Each button press changes the
hour indicator (A12) by 1 hour. Press 12 times to scroll through all 12 hours. Hold the + button (B8) for 3 seconds to
switch through the barometric pressure readings in millibars (hPa), inches of Mercury (inHg) or millimeters of Mercury (mmHG).
Barometric Pressure Bar Graph:
•
The barometric pressure reading at 0hr, –2hr,-4hr,-8hr,-12hr is recorded and shown on the barometric pressure bar graph
(A3). The graph is displayed in both hPa and inHg.
4
Slightly Cloudy
 
Indicating the barometric
pressure trend is steady
 
Cloudy
Sunny
 
 
Indicating the barometric
pressure trend is falling