GALA NEXUS Kullanıcı Kılavuzu - Sayfa 14
Banyo Armatürleri GALA NEXUS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. GALA NEXUS 16 sayfaları. Hydromassage bathtubs
Ayrıca GALA NEXUS için: Kurulum Kılavuzu (12 sayfalar)
Sayfayı Yazdır•
When you have finished the bath and once you are out of the bathtub:
14
1)
Pour into the water a measure of disinfecting cleaning liquid, in accordance with the cleaning liquid
manufacturer's instructions and the bathtub size.
2)
Set the hydromassage in operation for 2 minutes.
3)
Finally turn off the hydromassage and leave the disinfectant liquid to do its job for 20 minutes.
4)
Empty the bathtub.
NORMAL MAINTENANCE
To clean your hydromassage
after cleaning to avoid the training of calcareous plates.
Do not use elements which could damage the surface of the
Due to their concentration, we recommend to avoid some detergents and cleaning fluids not be used.
Never use solvents such as alcohol or acetone on the
pushbuttons or controls.
If the surface of the bathtub should accidentally be scratched containing the mentioned substances, it
should be enough to buff it with a solvent-free polish. If necessary, the surface can first be treated with a
sandpaper (Nº 800) and then a sandpaper (Nº1.200) before applying the polish.
Malfunctions
Should you notice any of the functions not operating as described in this manual, never allow anyone
except a qualified service engineer to service the interior of bath. We recommend you check through the
following table. Consult the following table and if necessary contact your Gala distributor.
MALFUNCTION
THE HYDROMASSAGE
DOES NOT START UP.
ONLY A SMALL NUMBER OF
BUBBLES COME OUT OF
THE NOZZLES.
Manual de usuario
bathtub
use a soft sponge, soap and water. The
POSSIBLE CAUSE
Fault in the mains power.
The magnetothermal or
differential switch has
tripped.
Water level too low.
Motor faulty or obstructed.
Level gauge badly regulated.
Regulator closed.
Jets with closed regulation
(only in some kind of jets).
User's manual
bathtub
, like abrasive or solvent products.
bathtub
nor any other chemical product to clean
Check the presence
of mains voltage.
Set them to closed circuit
If they trip again, DO NOT
continue to connect them and
contact your distributor.
Fill above the uppermost jet.
Contact your distributor.
Contact your distributor.
Operate the air regulator.
Turn the jets in the opposite
clockwise direction.
bathtub
should be dried
SOLUTION
position (ON).