Hidrotermal HIDRO-SW200 Kurulum ve Bakım Kılavuzu - Sayfa 3

Sualtı aydınlatması Hidrotermal HIDRO-SW200 için çevrimiçi göz atın veya pdf Kurulum ve Bakım Kılavuzu indirin. Hidrotermal HIDRO-SW200 4 sayfaları. Wall mounted underwater light

Sayfayı Yazdır

2. Installation

2.1 Preparing to Installation

1. Make sure the pool and its electrical system meets the requirements of the current national

or local electrical codes and ordinances.

2. This light can be installed in both concrete pools and fiber glass pools.

3. This light is designed to be used in new pools and/or pools with existing surface mounted

lights that need replacement.

4. Use only good quality stainless steel screws or screws provided along with the light.

5. The light must be used or operated while fully submerged underwater only. Never switch

on the light if it is not underwater.

2.2 Installation Notes

1.Make sure to install the bracket on a vertical wall of the pool.

2.Make sure the top of the light should be at least 450mm below normal water surface.

3.Reserve at least 150mm long backup wire wrapping on the back of the light, for the

convenience of replacing.

4.The junction box or the 12V low voltage transformer, should be located at least 300mm

above the water surface, at least 200mm above the ground, and at least 1200mm from the

edge of the pool.

5.To achieve synchronization, make sure all the lights are installed correctly on model and

characteristics as the one being replaced.