Celia & Perah M6 Kullanıcı Kılavuzu - Sayfa 8

Stereo sistemi Celia & Perah M6 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Celia & Perah M6 16 sayfaları. Wireless scalable hi-fi audio system

Sayfayı Yazdır

1. Bluetooth

Setting up

» Main Speakers operation:

① Short press the CONN. button on the Main Speaker control panel: the LED will go from

steady light to blinking, indicating that the Main Speaker has entered the C&P wireless

connection pairing mode. The Main Speaker will automatically search for nearby speakers

that can be connected.

② After pairing successfully, the LED indicators on the Subwoofer and the Zone 2 Speakers

will stop blinking, and the number of LEDs displayed on the Main Speaker's display will vary

accordingly to the configuration (a 2.1 configuration will be signalled by two LEDs, 4.1/6.1

configurations will be signalled by three LEDs);Now, press the CONN. button of the Main

Speaker again to exit pairing mode and stop searching for new speakers to connect.

Master speaker LED display explanation

No speakers connected

2.1 set-up

Tip: Main Speakers Main Speakers、 Zone 2 Speakers。

Main Speakers' left and right channels setting up

The active speaker is preset to be the left channel. If your power outlet is found on the right side,

you can switch the active speaker to the right channel by following the steps below.

Short press thePowerbutton on the control panel of

the Main Speaker to swap channels. The LED display

will show an R (right channel), and the slave speaker

will show an L (left channel).(After pressing the

power button again, the left and right channels will

be swapped again.）

Attention:The system will automatically return to

the default settings after powering it off.

4.1/6.1 set-up

Zone 2 Speakers' left and right channels setting up

The active speaker of the Zone 2 Speakers is pre-set to be the left channel. If your power outlet

is found on the right side, you can switch the active speaker to the right channel by following

the steps below.

Short press theCONN.button on the back of the active speaker

to swap to R (right channel);the slave speaker will beep to

indicate that it has been swapped to L (left channel).(Press

theCONN.button again and the left and right channels will be

swapped again.）

Testing the system

① 1. Connect an audio source from TV/PC/Blu-ray player/

Turntable.

② 2. Press the audio source button [OPT/Coaxial (COA)/USB

(USB)/3.5mm (AUX)] on the remote control to switch the

audio source from the preset one [Bluetooth (BT)] to the

audio source that is currently connected.

③ 3. The Main Speakers, the Subwoofer and the Zone 2

Speakers (if any) will start reproducing the sound.

④ 4. Press theMutebutton on the remote control.

⑤ The Main Speakers, the Subwoofer and the Zone 2 Speakers

(if any) will stop reproducing the sound.

Attention:If the audio source you are connecting to is a TV, turn

off the built-in speakers to avoid any sound distortion.For the

detailed steps, please refer to the TV user manual.

Setting up

MUTE