Aire 3828AR7314S Kurulum Talimatları Kılavuzu - Sayfa 13

Klima Aire 3828AR7314S için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Aire 3828AR7314S 16 sayfaları. Single split wall mounted air conditioner

Sayfayı Yazdır

CHECKING THE DRAINAGE AND FORMING THE PIPINGS

Checking the drainage

To remove the front panel from the indoor

unit, remove the front panel from the

indoor unit cabinet.

Set the air direction louvers up-and-down to

the position(horizontally) by hand.

Remove the securing screws that retain the

front panel. Pull the lower left and right

sides of the grille toward you and lift it off.

(18K, 24K, 26K Btu models: 3EA)

Pull the right and

the left side.

To check the drainage.

Pour a glass of water on the evaporator.

Ensure the water flows through the drain

hose of the indoor unit without any leakage

and goes out the drain exit.

Drain piping

The drain hose should point downward for

easy drain flow.

Do not make drain piping.

Accumulated

Do not raise

drain water

Air

Water

Waving

leakage

Screw

Downward slope

Tip of drain hose

Less than

dipped in water

50mm gap

Water

leakage

Ditch

Form the piping

Form the piping by wrapping the

connecting portion of the indoor unit with

insulation material and secure it with two

kinds of vinyl tapes.

If you want to connect an additional drain

hose, the end of the drain outlet should be

routed above the ground. Secure the drain

hose appropriately.

In cases where the outdoor unit is

installed below the indoor unit perform

the following.

Tape the piping, drain hose and

connecting cable from down to up.

Secure the tapped piping along the exterior

wall using saddle or equivalent.

Seal small openings

around pipings with a

gum type sealer.

Trap is required to prevent water

from entering into electrical parts.

In cases where the Outdoor unit is

installed above the Indoor unit perform

the following.

Tape the piping and connecting cable from

down to up.

Secure the taped piping along the exterior

wall. Form a trap to prevent water entering

the room.

Fix the piping onto the wall by saddle or

equivalent.

Taping

Drain

hose

Pipings

Connecting

cable

Trap