ADEN POWERKIT SPORT Kullanım ve Montaj Kılavuzu - Sayfa 6

Bisiklet ADEN POWERKIT SPORT için çevrimiçi göz atın veya pdf Kullanım ve Montaj Kılavuzu indirin. ADEN POWERKIT SPORT 16 sayfaları.

POWERKIT SPORT-ASSEMBLY INSTRUCTION

ADEN GmbH

ASSEMBLY

Needed tools:

» Allen key size 2,5

» Allen key size 3

» Allen key size 4

» TX 20 screwdriver

» Pocket rule

» Side cutter

» Cable tie

Assembly

Put the bicycle on an assembly stand or turn it upside down.

Remove the rear wheel and place the drive ring centrally.

Every spoke is between two screws.

Depending on the number of spokes you have to assemble the

appropriate ring.

36 spokes –> 18 clamps

32 spokes --> 16 clamps

28 spokes --> 14 clamps

Caution: The drive ring is always assembled on the left side

Fix all spoke clamps to the spokes. Pull the clamp from the wheel

rim towards the hub over the screws.

Slide all the spoke clamps onto the spokes.

The clamps snap into place under the bolt heads.

Tighten the bolts a little, so that the clamp can no longer

jump down but is still loose.

The ring must still be able to slide on the wheel to centre it.

www.aden-sports.com

EN | S. 6