Autonics BS5-P1ML Manuel - Sayfa 3

Aksesuarlar Autonics BS5-P1ML için çevrimiçi göz atın veya pdf Manuel indirin. Autonics BS5-P1ML 4 sayfaları. Push button type photomicro sensors

BS5-P Series

Dimensions

4-R3

6.5

Ø8

6-R3

Installation

When installing the product, tighten the screw with a tightening torque of 0.59N·m.

Do not pull the cable with a tensile strength of 30N or over. It may result in fire due to the broken wire.

1) Installation on non-flush surface

Install the sensor after fitting the sensor in the opening as shown in the figure below.

2) Installation on flush surface

Insert a spacer between the installation surface and the mounting surface of the sensor as shown in the figure below.

A-138

Operation indicator (red)

2-Ø3.2

21.3

3.7

Operation indicator (red)

Installation surface

Spacer

Installation

surface

Ø3, 1m

※ Recommended size

D: 6mm

d: 3.3mm

L: 4±0.1mm

(unit: mm)