galant 6160EX Kullanıcı Talimatları - Sayfa 8

Tuş takımı galant 6160EX için çevrimiçi göz atın veya pdf Kullanıcı Talimatları indirin. galant 6160EX 18 sayfaları.

Cancelling Alarms

If an alarm activation is in progress, whether the

system is set or unset, proceed directly to the

keypad and type in your User Code. This will

cancel the alarm condition and the display will

show the source of the alarm. Typically, this will

be the detection zone that caused the alarm

condition.

Please see the table at the end of this manual for a full list of alarm and

fault condition displays.

If the system is set and in alarm, the alarm can be cancelled using a

keyfob or keytag, by unsetting in the normal manner.

After an alarm has been cancelled and displayed, it must be reset. This

is typically done by typing your User Code again. The display will

return to the Day Mode display.

If the alarm message remains on the display, it may be that the alarm

condition has not been cleared. Check the source and type your User

Code again.

Installer Resets

Under certain conditions, it may not be possible to reset the alarm panel

by typing your User Code.

If you see this display, an installer reset is

required. Please contact your installer.

If you see this display, an 'Anti-Code' is

required from the monitoring station. Phone

the Station quoting the number on your

keypad display.

Intruder

ZN:07

RF SUP. ZN:14

Call Engineer

Reset Required

Call Engineer

Quote 12345