DBI SALA Sayfline Multi-span Wire Rope Horizontal Lifeline Kullanıcı Talimat Kılavuzu - Sayfa 10

Koruma Cihazı DBI SALA Sayfline Multi-span Wire Rope Horizontal Lifeline için çevrimiçi göz atın veya pdf Kullanıcı Talimat Kılavuzu indirin. DBI SALA Sayfline Multi-span Wire Rope Horizontal Lifeline 17 sayfaları.

Sayfayı Yazdır

Step 5. Inspect the intermediate brackets for wear or damage. Check brackets to make certain they

are securely attached. Make certain all installed Sayflink sleeves pass freely through the intermediate

brackets when moving along the system during normal use.

Step 6. Inspect system labels. The labels must be present and fully legible. See section 9.0. Replace

labels if missing or illegible.

IMPORTANT: If this equipment is subjected to the forces of a fall arrest, it must be removed from service and

destroyed, or returned to DBI/SALA for inspection or repair.

6.5

If inspection reveals an unsafe or defective condition, remove unit from service and destroy, or contact DBI/SALA

for possible repair.

6.6

USER EQUIPMENT: Inspect harnesses and energy absorbing lanyards or SRL's used with the HLL system

according to manufacturer's instructions.

7.0

MAINTENANCE, SERVICE, STORAGE

7.1

MAINTENANCE: The Sayfline components require no scheduled maintenance, other than repair or replacement of

items found defective during inspection. See section 6.0.

7.2

CLEANING: If components become heavily soiled with grease, paint, or other substances, clean with appropriate

cleaning solutions.

Remove dirt from the cable using a fiber brush. Do not use a wire brush and do not apply any solvents or

lubricants without prior approval from DBI/SALA.

Clean all other Sayfline components using a nonabrasive cloth and hot water/mild detergent mix. Dry with a clean

cloth. Do not use solvents to clean any Sayfline Component. Do not use caustic chemicals that could damage

system components.

7.3

USER EQUIPMENT: Maintain, service, and store system components according to manufacturer's instructions

for each component.

8.0

SPECIFICATIONS

8.1

MATERIALS:

Zorbit Energy Absorber: Stainless steel

Wire Rope: 3/8 inch diameter, 7x19 galvanized steel

Bolts: Grade 5 or Grade 8 zinc plated steel

Nuts: Zinc plated steel

Intermediate Brackets: 11 ga. hot rolled steel, zinc plated

Sayflink Sleeve Assembly: alloy steel

Shackles: Galvanized steel, 5,000 lbs. minimum tensile strength

Thimbles: Galvanized steel

Turnbuckle: Galvanized steel, 5,000 lbs. minimum tensile strength

Cable Clips: Galvanized steel

8.2

ENERGY ABSORBER PERFORMANCE:

Peak Dynamic Pullout Load: 2,500 lbs.

Average Dynamic Pullout Load: 2,000 lbs.

Maximum Pullout: 48.5 inches

Minimum Tensile Strength: 5,000 lbs.

Patents Pending