DBK Drymatic Boost Bar FGPH102 Kullanım Kılavuzu - Sayfa 15

Kurutucu DBK Drymatic Boost Bar FGPH102 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DBK Drymatic Boost Bar FGPH102 18 sayfaları. Adaptable heat drying system

Sayfayı Yazdır

Trouble Shooting:

In the event of a fault the first thing to try is powering down the machine, turning off the power at the mains and then waiting

ten seconds. You can then power it up again and see if there are any improvements. If not please refer to this troubleshooting

table for causes and solutions.

Fault

No power, red power switch is not

illuminated when in on position.

No display, red power switch

illuminates when in on position.

Unit not producing warm airflow. Fan

symbol is marked with a X

Unit not producing hot air. No Rotating

graphic is shown in hours display.

Drymatic Wall and Floor System not

inflating

In the event that this list does not cover your particular issue or the solution does not solve the problem

please contact your local Drymatic representative.

Cause

1) Plug fuse blown.

2) Fault with mains outlet or cord.

1) Internal fuse blown.

1) Insufficient airflow

1) Machine has not had sufficient time

to heat up.

2) Temperature setting is lower than

room ambient.

1) Insufficient airflow

Solution

Check plug fuse, if plug type doesn't

have a fuse contact service.

Check supply output and check cord for

any damage, breaks or cuts. If cord is

damaged seek replacement.

Check Internal fuse, it is located on the

switch panel next to the red power

switch. Replace if necessary.

Try positioning the air mover closer to

the Drymatic Boost Bar or use a higher

speed setting. Check that the air mover

meets the minimum requirements.

The machine will check for stable

airflow before gradually ramping up

power. This can take up to five

minutes.

Increase the temperature setting, it

may be that the room is hotter than

the temperature limit set.

Try positioning the air mover closer to

the Drymatic Boost Bar or use a higher

speed setting. Check that the mat is

well sealed around the Drymatic Boost

Bar and free to inflate. The minimum

recommended airflow of 1100m³/Hr

(650 cfm) is the requirement for the

Drymatic

Boost

Bar

correctly. Inflating mats, depending on

configuration, may require significantly

function