ADENDORFF MCJ1000 Montaj ve Kullanım Kılavuzu - Sayfa 7
Elektrikli Alet ADENDORFF MCJ1000 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Kılavuzu indirin. ADENDORFF MCJ1000 13 sayfaları. Wood lathe 14 x 40 inch
Sayfayı YazdırTurning the Wood Stock
Caution:
ANSI approved eye protection, and do not have any loose clothing or
long hair exposed.
1.
Lay out your selection of gouges and chisels. You may wish to mark indicator lines
along the length of the wood stock to mark points of transition or design change.
2.
Plug the Wood Lathe Power Line (1) into an appropriate outlet.
Turn on the Wood Lath by pressing the Power Switch (30) to "ON" and allow it to
3.
come up to speed.
Caution: If the wood stock begins to wobble or is unstable, immediately
turn lathe OFF and reposition wood stock.
4.
Place the desired gouge or chisel onto the Tool Carriage (35). Make sure the cutting
edge of the gouge or chisel is oriented properly for the Wood Lathe direction of
rotation.
5.
Gently press the gouge or chisel forward into the spinning wood stock. Move the
tool forward in small increments. This is especially important with a fresh, square
piece of wood stock.
6.
If you press the gouge or chisel forward too fast, you may cause the Wood Lathe to
stall. The spinning wood stock may also knock the tool from your hand. Use
Caution.
7.
Move the gouge or chisel slowly up and down the length of the Tool Carriage to shape
the wood stock. When shaping the wood stock, use patience and care. Do not force
the tool into the wood stock or try to take too great an amount of wood off at one
time.
8.
When the wood stock has been roughly shaped for part of its length, you can move
the Tool Carriage to the section of the unshaped wood.
9.
When the entire length or wood stock has been roughly formed into a cylindrical
shape, you can switch to your final shaping and decorating gouges and chisels.
10. When you are done shaping your wood stock, turn the Power Switch (30) to "OFF".
11
Turn the Hand wheel (43) counterclockwise and removed the shaped wood stock.
Using the Chuck
For the following steps you need a piece of wood stock 1 inch thick by at least five inches in
diameter
1.
Attach your wood stock piece to the Face plate (29) using wood screws inserted
through the back of the Chuck into the wood Stock.
2.
Attach the chuck as described under Adjustments below.
3.
Turn the wood stock until it is completely circular and slightly larger in diameter than
the Chuck.
Before turning on the Wood Lathe, make sure to wear