Hifonics XXV-Colossus Kullanıcı Kılavuzu - Sayfa 13
Amplifikatör Hifonics XXV-Colossus için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Hifonics XXV-Colossus 20 sayfaları. Xxv edition high performance amplifier
Sayfayı Yazdır
XXV MAXXIMUS DUAL MONO BLOCK AMPLIFIER APPLICATIONS
BASIC APPLICATION
The 2 channel mono amplifiers are capable of 4, 2 & 1 Ohm loads wired channels 1 & 2
independent as shown below or 4 or 2 Ohms wired mono bridged shown below.
The XXV-MAXXIMUS has two 5000 watt D-Class channels built-in labeled Subwoofer 1
& Subwoofer 2 on the end panel.
SINGLE AMP INSTALLATION PROCEDURE:
1. Connect the amp LINE INPUTS to the Radio/CD player full range or mono line out puts with good
quality RCA interconnect cables.
2. Plug in the XXVR-1 bass remote module into the amp REMOTE INPUT jack.
3. Route two 0 gauge power cables directly to the vehicle battery with an in-line 300 amp fuse.
DESIGNATED MONO
LINE INPUT
USING CHANNELS 1 & 2 INDEPENDENTLY
POWER
GND
+12V
REM
POWER
GND
+12V
-
Note: The amp is capable of driving 4, 2 or 1-Ohm per sub in this configuration
Impedances below 1-Ohm will damage the amplifier
FULL RANGE
STEREO LINE INPUT
NOT USED
SUBWOOFER 1
POWER
-
-
+
+
+12V
GND
POWER
-
+12V
GND
+
+
SUBWOOFER 2
This will allow you to operate separate subs independently (on each channel 1 or 2) at 4, 2 or
1 Ohm at up to 5000 watts or bridged across 1& 2 to operate a single sub up to 10000 watts
at 4 or 2 Ohms.
Note: The amp is not capable of 1 Ohm when bridged across 1 & 2.
The crossovers and XXVR-1 Bass Remote Module will operate both 1 & 2 channels
simultaneously.
4. Connect two 0 gauge ground cables directly to chassis ground with in 36" of the amp.
- Be sure to remove any paint or primer from the ground point.
- Use a nut, bolt and lock washer to secure the ground cable to the chassis ground.
5. Connect the subwoofer(s) in accordance to the diagrams below.
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line
output or a full range stereo line output. For full range
stereo line output, you will need an optional "Y-Adaptor"
as shown
USING CHANNELS 1 & 2 MONO BRIDGED
POWER
GND
POWER
GND
Note: The amp is capable of driving 4 or 2-Ohms in this configuration
Impedances below 2-Ohms will damage the amplifier
TO BATTERY +12v VIA FUSE
REMOTE TURN-ON
TO BATTERY +12v VIA FUSE
SUBWOOFER 1
-
-
+12V
+
+
REM
BRI
DGI G UM
N J
+12V
-
-
+
+
SUBWOOFER 2
Caution: You must place a 12 gauge mono
Bridged Jumper Wire as shown above
CHASSIS GROUND
CHASSIS GROUND
POWER
+12V
GND
PER
POWER
+12V
GND
11