ADENDORFF MCll00 Kullanım Kılavuzu - Sayfa 13

Torna Tezgahı ADENDORFF MCll00 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ADENDORFF MCll00 18 sayfaları. Variable speed wood lathe

Sayfayı Yazdır

--- -- --

- - -

-----

Switch (Figure 12)

1. To tum the lathe •oN•, insert the yellow switch

key Into the switch housing.

2. Move the switch to the •oN· position.

3. To tum the lathe ·oFF·, move the switch

·oFF·

to the

position.

4. To lock the switch In the

remove the yellow switch key from the switch

housing. Store it in a safe place.

5. Never leave the lathe unattended until it has

come to a complete stop.

Speed control (Figure 13)

1. The lathe motor must be running before you

can use the speed control lever.

2. T he speed control lever can be turned to one

of ten fixed speeds. To set the speed, pull back

on the lever handle [1] and rotate the handle to

the next fixed speed. Use the index plate [2] to

choose lathe speed.

3. Tum the lever clockwise to increase the speed

and counterclockwise to decrease the speed.

4. You must move the speed control lever to

the lowest speed setting before turning the

switch off (Figure 14), otherwise the motor

may not start.

Tailstock (Figure 15)

1. Move the tailstock [1] by loosening the lock

lever [2] and pushing the tails1ock

desired position on the bed. Lock by

tightening the lock lever (2].

2. The spindle can extend up to 2-1/2 inches

from the tailstock housing. You can move the

tailstock spindle [3] by loosening the spindle

lock lever [4] and then turning the

hand wheel [5]. Lock levers [4} and [2]

before operating lathe.

3. The tailstock spindle is hollow and can be

accessed from the handwheel end. Use the

push-out rod to remove the center cup or to drill

holes through the center of a workpiece.

'-------------------11 3 1-------------------'

- -

-- ·-··· ·

-- ·- --

Vll. Operation

'OFP

position,

the

Fig. 12

p=<-�----.i1

r----------_ -_-_-_-_----.-,-----,--,

Fig. 14

Flg. 15