909 254CMS Kullanım Kılavuzu - Sayfa 11

Testere 909 254CMS için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. 909 254CMS 19 sayfaları. 1800w 255mm (10") single bevel laser guided compound mitre saw

Sayfayı Yazdır

Mitre table lock

The mitre table lock (15) is

used to lock the table at the

desired mitre angle (Fig. E).

The mitre saw cuts from 0°

to 45° both left and right.

To adjust the mitre angle

loosen the mitre table lock

and depress the mitre lever

to allow the table to rotate,

rotate to the desired mitre

angle and lock the table in place. The mitre table features

positive click stops at 0°, 15°, 22.5°, 30° and 45° for quick

setting of common mitre angles.

WARNING.

Be sure to tighten the mitre table lock before

making a cut. Failure to do so could result in the table

moving during the cut and cause serious personal injury.

Bevel lock

The bevel lock (7) is used to

set the blade at the desired

bevel angle (Fig. F). The

mitre saw bevel cuts from 0°

to 45° to the left. To adjust

the bevel angle loosen the

bevel lock. Adjust the saw

arm to the desired bevel

angle.

WARNING.

Be sure to tighten the bevel lock before making

a cut. Failure to do so could result in the saw arm moving

during the cut and cause serious personal injury.

Bevel adjuster

To return the saw arm to the

vertical (0° bevel) position

move the saw arm to the left.

Return the saw blade to

the vertical position, it will

automatically stop at the 0°

bevel position. Tighten the

bevel lock.

Clamp assembly

The clamp assembly can be mounted to the fence, either

side of the saw blade, to suit the task at hand (Fig. H).

Use the clamp assembly lock (23) at the back of the fence

to secure the clamp assembly in position (Fig. I). (Fig. J).

(Fig. K).