GALAXIS SHOWTECHNIK PYROTEC PFS Pocket Kullanıcı Kılavuzu - Sayfa 6

Verici GALAXIS SHOWTECHNIK PYROTEC PFS Pocket için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. GALAXIS SHOWTECHNIK PYROTEC PFS Pocket 17 sayfaları.

Sayfayı Yazdır

- 6 -

28. Along with sufficient lengths of firing wire you should also

ensure the following:-

In the field of display fireworks: The aerial shells or mines must

only be loaded after the mortar tubes have been stabilized and

secured. It is only after the loading of the tubes are completed

that it is permissible to connect the e-matches to their respective

firing units. At all times the most important rule is to never put

your head or other body parts into or over a mortar tube. This would

also apply to other pyrotechnic effects.

In the field of special effects: Depending on the explosive power of

the pyrotechnic effects or materials that are being used it is

advisable to proceed with more care and attention (lies within the

pyrotechnican's responsibility) and this could include for example a

short circuit bridge over the contacts of the e-match to prevent

unintended firing. Also it is possible to make a physical switch

breakage in the firing line, which is only then closed when all

safety regulations are met and kept! Should there be any unclarified

situations, then discussions with the safety authorities are to take

place until everything is clarified and understood by everyone. When

it comes to the safety of your projects we are available to assist

you to develop a customized safety procedure.

29. Make sure the devices are switched off before connecting the e-

matches.

30. When stripping the cable insulation of the igniters and

connecting them, you must ensure that they are not stripped so far

back that the exposed conductors can touch each other. Short

circuits between different outputs must be avoided because this may

cause unwanted firings.

31. When checking the various system parameters as well as during

firing, nobody is allowed within the danger zone.

32. After the effects have been fired, an ample amount of time

should be given before disassembling the pyrotechnical setup to

ensure that any unfired material can safely be located and dealt

with. Before securing possible unfired effects first switch off the

receivers, and then disconnect the corresponding wiring. In the

field of special effects, care must be taken during disassembly of

unfired effects or installations. Work must be conducted in a safe

way, and must only be carried out by a competent person.

33. Make sure that only original parts (e.g. chargers, connectors,

etc.) are used. Otherwise the warranty and claims under product

liability will be invalidated.

34. When using receivers inside Zarges cases it is important to

ensure that the case lid (aluminum top) is closed and latched shut

during the fireworks display. There is still enough space for the

wires of the e-matches to go out on both sides of the case. This

guarantees the safety and protection of the receiver and also

prevents the top of the case opening in windy conditions.